Directed Electronics Ready Remote manual Safety Shutdown Wires

+12 VDC CONSTANT (FUSED 20A)

							STARTER RELAY
							(NOT PROVIDED)
	TO STARTER		87				GROUND
						85
		86		87A
			30
						TO STARTER
	+12 VDC CONSTANT (FUSED 20A)
							2nd STARTER RELAY
							(NOT PROVIDED)
VIOLET (+) OUTPUT
		87
TO STARTER							GROUND
						85
		86
				87A
			30
					TO 2nd STARTER

➜

step 4

Safety Shutdown Wires

warning! These wires are meant to protect the vehicle and anyone near the vehicle. They must be connected appropriately to prevent damage to the vehicle and possible bodily injury. Failure to properly install these wires may cause the vehicle to lunge if remote started while in gear.

With all ignition wires properly connected, find the appropriate safety shutdown wires. These are the brake wire and hood pin wires.

First locate the factory brake wire using your test probe. Find the switch at the top of the metal arm coming off the brake pedal. There are usually two wires connected to that switch. Locate the

20 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s