INSTALLATION & OPERATIONAL SSHLV SERIES MANUAL
3.3.FILLING THE FRY POT
Only use shortening that is liquid at room temperature in this appliance.
CAUTION
This appliance is NOT designed for cooking with water. Fill with oil or shortening only.
WARNING
This appliance is not designed for use with solid shortening. Using solid shortening will cause the filter pump and oil lines to become plugged, and require professional service personnel to fix.
3.4.FILLING THE TANK WITH LIQUID SHORTENING
To fill the tank with liquid shortening, refer to the following procedure.
FRY POT OIL CAPACITY: | SSHLV14 = 30 lbs (13.6 kg) |
| SSHLV14T = 17 lbs (6.8 kg) |
It is recommended that high quality liquid frying oils be used for longest oil life.
1.Verify that the tank interior is clean and free of any construction debris.
2.Rinse the tank and drain line with a small amount of clean cooking oil.
3.Ensure that the drain valve is closed.
4.Fill the tank to the “MIN” level mark. The oil will expand when heated up, raising the level to OIL LEVEL line.
5.After the cooking oil is at operating temperature, add oil to the frypots as needed to obtain the desired operating level.
WARNING
THE PUSH BUTTON TOP OFF SYSTEM IS NOT INTENDED TO FILL FRY POTS.
WARNING
Replace shortening that is smoking, or foams when cooking. Old shortenings have reduced flash point, and are prone to surge boiling. Using old shortening may create dangerous conditions
WARNING
Do not overload the fry baskets, or allow the oil level to exceed the MAX line while cooking. Wet product, or too much oil in the frypot can lead to surge boiling, and over topping the frypot. Overtopping may create hazards such as burns or slippery floors.
CAUTION
This appliance is NOT designed for cooking with water. Severe equipment damage will occur if
a fryer is used as a water bath for rethermalizing foods.
WARNING
Oil must completely cover the heating tubes at all times while appliance is on.
16 |