Sharp FONS2 operation manual Setting the IP Address, Press Menu and then, Press Enter

Page 10

1. Setting the IP Address

Once your dealer has installed the network scanner option and the machine is connected to the network, the network administrator or administrator of the machine should use the following procedure to set the IP address of the machine.

Note: Although “DHCP” is available as a setting for the IP address (this means that the machine automatically obtains an address from a DHCP server), it is recommended that a permanent IP address be assigned to the machine. If DHCP must be used, it is recommended that the DHCP lease time for the IP address be set to unlimited. To check the IP address currently assigned to the machine when DHCP is used, print out the network setting list as explained on page 9.

1 Press MENU and then

.

Make sure that NETWORK SETTING is selected in the display.

Display:

MENU MODE 5:PROGRAM/GROUP MODE 6:SERIAL POLLING MODE 7:MEMORY POLL MODE 8:NETWORK SETTING

2 START/

Press ENTER .

Make sure that NETWORK CONFIG SET is selected.

NETWORK SETTING 1:NETWORK CONFIG SET 2:SCAN TO E-MAIL SET-UP 3:NETWORK SETTING LIST

3

4

Press

START/

NETWORK CONFIG SET

 

ENTER .

1:IP ADDRESS SETTING

 

 

 

 

Make sure that IP ADDRESS

2:INITIALIZE THE NIC

 

 

 

SETTING is selected.

 

 

 

 

 

 

 

 

 

 

Press

START/

IP ADDRESS SETTING

 

ENTER .

ENABLE DHCP

 

 

 

 

 

 

1=YES

 

 

 

2=NO

 

 

 

 

 

6

Image 10
Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Press Enter Setting the IP AddressPress Menu and then PressEnter the IP gateway. When finished, press Enter Right, press . When finished, press EnterEnter the IP subnet mask. When finished, press Enter If you are entering a permanent IPInitializing the network interface board Printing out the Network Settings ThenAccessing the Web page in the machine Mail Server and DNS Server SettingsMail server and DNS server Setting Passwords Network Scanning and Sender E-mail settingsStoring Network Scanning Destinations Storing destinations in the Web Scan to FTP Hyperlink Creating personal books in the WebInformation on using Scan to Desktop Scan to E-mail Setup Until Scan to E-MAIL SET-UP is selectedTo change case, press To enter a space, pressTo clear a mistake, press DEL Then press Press the letter keys to enter your e-mail address see StepTime display Scan to E-mail Using the E-mail Key Load the documentsPress Enter . Change the selected option as follows Press Enter If you wish to enter a messagePress to select the option you want to change, and then Press Enter . The document is scanned and transmittedSending an image using a Rapid Key Sending an Image Using a Rapid Key or Speed Dial NumberPress the appropriate Rapid Key Enter your name, press Press Enter to begin scanning and transmissionSending an image using a Speed Dial number Numeric keysIf the destination is an e-mail Press Enter . Make sure that Destination Setting is selected Press Enter . Make sure that SET is selectedEnter to complete the entry Press To select E-MAIL Editing a Rapid Key or Speed Dial number Clearing a Rapid Key or Speed Dial numberSharpdesk Desktop Document Management Software Installing the Network Scanner SoftwareSoftware Programs Network Scanner ToolInstalling Acrobat Reader Users Guides for Software ProgramsInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Troubleshooting Problem Scan to E-mail is not successful Check SolutionProblem Cannot connect to the network Check Solution Error Message at the Communication ErrorProblem Takes a long time to send an image Error Code Table Description of the ErrorPage Warranty Sharp Corporation