Sharp FONS2 operation manual Warranty

Page 42

(Australia Only)

WARRANTY

Facsimile Products

Congratulations on Your Purchase!

This Sharp product is warranted against manufacturing defects for a period of twelve (12) months from the date of original purchase.

In the event of any defect arising in the equipment during the warranty period, such repairs should only be carried out by the Dealer from which the unit was originally purchased or a Service Centre approved by Sharp to service this type of equipment. These repairs would be carried out at no charge to the owner, subject to the conditions specified herein.

The owner is responsible for any transportation and insurance costs if the product has to be returned for repair.

This warranty does not extend to accessories or defects or injuries caused by or resulting from causes not attributable to faulty parts or the manufacture of the product, including but not limited to, defect or injury caused by or resulting from misuse, abuse, neglect, accidental damage, improper voltage, liquid spillage, vermin infestation, software, use of consumables other than those approved by Sharp, or any alterations made to the product which are not authorised by Sharp.

Please retain your sales documentation, as this should be produced to validate a warranty claim.

This warranty is in addition to and in no way limits, varies or excludes any express and implied rights and remedies under any relevant legislation in the country of sale. However, to the extent permitted by such legislation, Sharp excludes any liability for any indirect or consequential damages arising from the purchase or use of the product.

To the extent permitted by law, Sharp excludes all implied warranties and conditions and where the product is one that is not normally required for personal, domestic or household use, Sharp limits its liability to the repair or replacement (at Sharp's option) of materials or workmanship which are found by Sharp to be defective.

For your reference, please enter the particulars of your purchase below and retain, with your purchase documentation.

Model No.

Serial No.

Date of Purchase

Place of Purchase

SPform046 (Dec2001)

FOR LOCATION ENQUIRIES WITHIN

AUSTRALIA

REGARDING YOUR LOCAL

SHARP APPROVED SERVICE CENTRE

CALL SHARP

LOCAL CALL: 1 300 135 022

FACSIMILE: (02) 9672 1210

WEB: www.sharp.net.au

SHARP CORPORATION OF AUSTRALIA PTY. LIMITED

A.B.N. 40 003 039 405

1 Huntingwood Drive, Huntingwood NSW 2148

1Important Notice: This warranty applies only to products sold in Australia

Page 41 Page 43
Image 42
Page 41 Page 43
Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Press Enter Setting the IP AddressPress Menu and then PressEnter the IP gateway. When finished, press Enter Right, press . When finished, press EnterEnter the IP subnet mask. When finished, press Enter If you are entering a permanent IPInitializing the network interface board Printing out the Network Settings ThenMail Server and DNS Server Settings Accessing the Web page in the machineMail server and DNS server Setting Passwords Network Scanning and Sender E-mail settingsStoring Network Scanning Destinations Storing destinations in the Web Scan to FTP Hyperlink Creating personal books in the WebInformation on using Scan to Desktop Scan to E-mail Setup Until Scan to E-MAIL SET-UP is selectedTo enter a space, press To change case, pressTo clear a mistake, press DEL Press the letter keys to enter your e-mail address see Step Then pressTime display Scan to E-mail Using the E-mail Key Load the documentsPress Enter . Change the selected option as follows Press Enter If you wish to enter a messagePress to select the option you want to change, and then Press Enter . The document is scanned and transmittedSending an Image Using a Rapid Key or Speed Dial Number Sending an image using a Rapid KeyPress the appropriate Rapid Key Enter your name, press Press Enter to begin scanning and transmissionSending an image using a Speed Dial number Numeric keysIf the destination is an e-mail Press Enter . Make sure that Destination Setting is selected Press Enter . Make sure that SET is selectedEnter to complete the entry Press To select E-MAIL Editing a Rapid Key or Speed Dial number Clearing a Rapid Key or Speed Dial numberSharpdesk Desktop Document Management Software Installing the Network Scanner SoftwareSoftware Programs Network Scanner ToolInstalling Acrobat Reader Users Guides for Software ProgramsInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Troubleshooting Problem Scan to E-mail is not successful Check SolutionProblem Cannot connect to the network Check Solution Error Message at the Communication ErrorProblem Takes a long time to send an image Error Code Table Description of the ErrorPage Warranty Sharp Corporation
Top Page Image Contents