Sharp FONS2 Mail Server and DNS Server Settings, Accessing the Web page in the machine

Page 14

3. Mail Server and DNS Server Settings

Settings for your E-mail server and DNS server must be configured in order to use the network scanner function. To configure the settings, access the machine's Web page from a computer that is connected to the same network as the machine. The Web page can be displayed with your Web browser (Internet Explorer 4.0 or later, or Netscape Navigator 4.0 or later).

Accessing the Web page in the machine

To access the Web page in the machine, type in the IP address of the machine in your browser in the format http://XXX.XXX.X.X, where the X’s are the IP address (the number of digits between periods will vary depending on the address). If you need to check the IP address of the machine, print out the network settings as explained on page 9.

Mail server and DNS server

To configure your mail server and DNS server settings, click E-mail & DNS in the menu at the left of the Web page and enter the information in the appropriate boxes.

Note that your DNS server must be entered if you enter a host name instead of an IP address in E-mail Server under E-mail Setup. This is also true if host names will be used for Scan to FTP or Scan to Desktop destinations.

♦If “DHCP” was selected for the IP address of the machine, the IP address of the DNS server appears automatically and cannot be changed.

10

Image 14

Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Press Enter Setting the IP AddressPress Menu and then PressEnter the IP gateway. When finished, press Enter Right, press . When finished, press EnterEnter the IP subnet mask. When finished, press Enter If you are entering a permanent IPInitializing the network interface board Printing out the Network Settings ThenMail server and DNS server Mail Server and DNS Server SettingsAccessing the Web page in the machine Setting Passwords Network Scanning and Sender E-mail settingsStoring Network Scanning Destinations Storing destinations in the Web Scan to FTP Hyperlink Creating personal books in the WebInformation on using Scan to Desktop Scan to E-mail Setup Until Scan to E-MAIL SET-UP is selectedTo clear a mistake, press DEL To enter a space, pressTo change case, press Time display Press the letter keys to enter your e-mail address see StepThen press Scan to E-mail Using the E-mail Key Load the documentsPress Enter . Change the selected option as follows Press Enter If you wish to enter a messagePress to select the option you want to change, and then Press Enter . The document is scanned and transmittedPress the appropriate Rapid Key Sending an Image Using a Rapid Key or Speed Dial NumberSending an image using a Rapid Key Enter your name, press Press Enter to begin scanning and transmissionSending an image using a Speed Dial number Numeric keysIf the destination is an e-mail Press Enter . Make sure that Destination Setting is selected Press Enter . Make sure that SET is selectedEnter to complete the entry Press To select E-MAIL Editing a Rapid Key or Speed Dial number Clearing a Rapid Key or Speed Dial numberSharpdesk Desktop Document Management Software Installing the Network Scanner SoftwareSoftware Programs Network Scanner ToolInstalling Acrobat Reader Users Guides for Software ProgramsInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Troubleshooting Problem Scan to E-mail is not successful Check SolutionProblem Cannot connect to the network Check Solution Error Message at the Communication ErrorProblem Takes a long time to send an image Error Code Table Description of the ErrorPage Warranty Sharp Corporation