Sharp FONS2 operation manual Installing the software programs

Page 34

Installing the Network Scanner Software

Installing the software programs

Note the following when installing the software programs from the CD-ROM:

♦Be sure to check the system requirements for installation of each of the software programs in the user's guides and on the information screen during installation.

♦For detailed instructions for installing and setting up the programs, see the Sharpdesk Installation Guide on the CD-ROM.

♦If you perform a standard installation of Sharpdesk (select Typical in the installation type selection screen), Network Scanner Tool will also be installed. You can also select Custom installation and install only Network Scanner Tool.

♦If your computer does not currently have Internet Explorer version 5.5 or later installed, Sharpdesk will install a minimal version of Internet Explorer 5.5 on your computer.

1Quit any software applications and/or resident programs that are running on your computer.

2Insert the CD-ROM into your CD-ROM drive.

• If the Sharpdesk installation screen appears. go to Step 6.

• If the screen does not appear, continue with Step 3.

3Double-click "My Computer" ().

4Double-click the CD-ROM icon ().

5Double-click the Sharpdesk folder, and then double-click SETUP ().

6Follow the instructions on the screen.

• In the license number entry line in the user information screen, enter the license number that appears on the cover of this manual.

30

Image 34

Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Press Enter Setting the IP AddressPress Menu and then PressEnter the IP gateway. When finished, press Enter Right, press . When finished, press EnterEnter the IP subnet mask. When finished, press Enter If you are entering a permanent IPInitializing the network interface board Printing out the Network Settings ThenAccessing the Web page in the machine Mail Server and DNS Server SettingsMail server and DNS server Setting Passwords Network Scanning and Sender E-mail settingsStoring Network Scanning Destinations Storing destinations in the Web Scan to FTP Hyperlink Creating personal books in the WebInformation on using Scan to Desktop Scan to E-mail Setup Until Scan to E-MAIL SET-UP is selectedTo change case, press To enter a space, pressTo clear a mistake, press DEL Then press Press the letter keys to enter your e-mail address see StepTime display Scan to E-mail Using the E-mail Key Load the documentsPress Enter . Change the selected option as follows Press Enter If you wish to enter a messagePress to select the option you want to change, and then Press Enter . The document is scanned and transmittedSending an image using a Rapid Key Sending an Image Using a Rapid Key or Speed Dial NumberPress the appropriate Rapid Key Enter your name, press Press Enter to begin scanning and transmissionSending an image using a Speed Dial number Numeric keysIf the destination is an e-mail Press Enter . Make sure that Destination Setting is selected Press Enter . Make sure that SET is selectedEnter to complete the entry Press To select E-MAIL Editing a Rapid Key or Speed Dial number Clearing a Rapid Key or Speed Dial numberSharpdesk Desktop Document Management Software Installing the Network Scanner SoftwareSoftware Programs Network Scanner ToolInstalling Acrobat Reader Users Guides for Software ProgramsInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Troubleshooting Problem Scan to E-mail is not successful Check SolutionProblem Cannot connect to the network Check Solution Error Message at the Communication ErrorProblem Takes a long time to send an image Error Code Table Description of the ErrorPage Warranty Sharp Corporation