Sharp FONS2 operation manual Printing out the Network Settings, Then

Page 13

2. Printing out the Network Settings

You can print lists showing the current network settings and network interface board settings.

♦To check the IP address of the machine, select PRINT NETWORK SETTINGS in Step 3 below.

1 Press MENU and then

.

•Make sure that NETWORK SETTING is selected in the display.

Display:

MENU MODE 5:PROGRAM/GROUP MODE 6:SERIAL POLLING MODE 7:MEMORY POLL MODE 8:NETWORK SETTING

2

3

	Press	START/	and then	.	NETWORK SETTING
	Press	ENTER	and then	.	1:NETWORK CONFIG SET
					1:NETWORK CONFIG SET
	• Make sure that NETWORK				2:SCAN TO E-MAIL SET-UP
	• Make sure that NETWORK				3:NETWORK SETTING LIST
	SETTING LIST is selected.				3:NETWORK SETTING LIST
	SETTING LIST is selected.
	Press	START/			NETWORK SETTING LIST
	Press	ENTER .			1:PRINT NETWORK SETTINGS
					1:PRINT NETWORK SETTINGS
					2:PRINT NIC INFORMATION

4 Press

START/

press ENTER

board”.)

or to select the list you want to print, and then

. (Note: “NIC” is an acronym for “network interface

9

Image 13

Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Press Menu and then Setting the IP AddressPress Enter PressEnter the IP subnet mask. When finished, press Enter Right, press . When finished, press EnterEnter the IP gateway. When finished, press Enter If you are entering a permanent IPInitializing the network interface board Then Printing out the Network SettingsAccessing the Web page in the machine Mail Server and DNS Server SettingsMail server and DNS server Network Scanning and Sender E-mail settings Setting PasswordsStoring Network Scanning Destinations Storing destinations in the Web Creating personal books in the Web Scan to FTP HyperlinkInformation on using Scan to Desktop Until Scan to E-MAIL SET-UP is selected Scan to E-mail SetupTo change case, press To enter a space, pressTo clear a mistake, press DEL Then press Press the letter keys to enter your e-mail address see StepTime display Load the documents Scan to E-mail Using the E-mail KeyPress to select the option you want to change, and then Press Enter If you wish to enter a messagePress Enter . Change the selected option as follows Press Enter . The document is scanned and transmittedSending an image using a Rapid Key Sending an Image Using a Rapid Key or Speed Dial NumberPress the appropriate Rapid Key Press Enter to begin scanning and transmission Enter your name, pressNumeric keys Sending an image using a Speed Dial numberIf the destination is an e-mail Press Enter . Make sure that SET is selected Press Enter . Make sure that Destination Setting is selectedEnter to complete the entry Press To select E-MAIL Clearing a Rapid Key or Speed Dial number Editing a Rapid Key or Speed Dial numberSoftware Programs Installing the Network Scanner SoftwareSharpdesk Desktop Document Management Software Network Scanner ToolUsers Guides for Software Programs Installing Acrobat ReaderInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Problem Scan to E-mail is not successful Check Solution TroubleshootingProblem Takes a long time to send an image Error Message at the Communication ErrorProblem Cannot connect to the network Check Solution Error Code Table Description of the ErrorPage Warranty Sharp Corporation