Sharp FONS2 operation manual Setting up Network Scanner Tool

Page 35

Installing the Network Scanner Software

•If you select Typical in the installation type screen, Network Scanner Tool will also be installed. If you only wish to install Network Scanner Tool, select Custom in the installation type screen and then check only Network Scanner Tool.

•Sharpdesk Imaging is installed together with Sharpdesk. If Imaging for Windows was previously installed, Sharpdesk Imaging will overwrite Imaging for Windows.

•The Sharpdesk installation package contains Sharpdesk Imaging, which is a version of Eastman Software's “Imaging for Windows Professional Edition” that has been customized for the Sharp Corporation. If Eastman Software's “Imaging for Windows Professional Edition” has already been installed on your computer, Sharpdesk Imaging will not be installed.

•“Imaging for Windows Professional Edition” and Sharpdesk Imaging use common registry entries, and installing “Imaging for Windows Professional Edition” after Sharpdesk has been installed may cause abnormal operation. In this case, uninstall Sharpdesk and Sharpdesk Imaging, and then install “Imaging for Windows Professional Edition”. After that, reinstall Sharpdesk.

Setting up Network Scanner Tool

When installation of the software is completed, the Sharp Network Scanner Tool Setup Wizard will appear. Follow these steps to set up the Network Scanner Tool.

♦The FO-DC500/600 is referred to as “Copier” in the windows of the setup wizard.

1When the Sharp Network Scanner Tool Setup Wizard appears, click

OK after confirming that the FO-DC500/600 is connected to the network. Follow the on-screen instructions to complete the setup.

31

Image 35

Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Press Setting the IP AddressPress Menu and then Press EnterIf you are entering a permanent IP Right, press . When finished, press EnterEnter the IP subnet mask. When finished, press Enter Enter the IP gateway. When finished, press EnterInitializing the network interface board Then Printing out the Network SettingsMail server and DNS server Mail Server and DNS Server SettingsAccessing the Web page in the machine Network Scanning and Sender E-mail settings Setting PasswordsStoring Network Scanning Destinations Storing destinations in the Web Creating personal books in the Web Scan to FTP HyperlinkInformation on using Scan to Desktop Until Scan to E-MAIL SET-UP is selected Scan to E-mail SetupTo clear a mistake, press DEL To enter a space, pressTo change case, press Time display Press the letter keys to enter your e-mail address see StepThen press Load the documents Scan to E-mail Using the E-mail KeyPress Enter . The document is scanned and transmitted Press Enter If you wish to enter a messagePress to select the option you want to change, and then Press Enter . Change the selected option as followsPress the appropriate Rapid Key Sending an Image Using a Rapid Key or Speed Dial NumberSending an image using a Rapid Key Press Enter to begin scanning and transmission Enter your name, pressNumeric keys Sending an image using a Speed Dial numberIf the destination is an e-mail Press Enter . Make sure that SET is selected Press Enter . Make sure that Destination Setting is selectedEnter to complete the entry Press To select E-MAIL Clearing a Rapid Key or Speed Dial number Editing a Rapid Key or Speed Dial numberNetwork Scanner Tool Installing the Network Scanner SoftwareSoftware Programs Sharpdesk Desktop Document Management SoftwareUsers Guides for Software Programs Installing Acrobat ReaderInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Problem Scan to E-mail is not successful Check Solution TroubleshootingError Code Table Description of the Error Error Message at the Communication ErrorProblem Takes a long time to send an image Problem Cannot connect to the network Check SolutionPage Warranty Sharp Corporation