Sharp FONS2 operation manual Initializing the network interface board

Page 12

JOB STATUS

JOB STATUS

Setting the IP Address

11 Wait while the machine writes the setting to the NIC board (“DO

NOT POWER DOWN” will appear in the display). When the display changes to “OK”, turn off the power of the machine and then turn it back on to make the new settings take effect. (Before turning off the power, make sure the machine is not in the middle of a job: 1) check whether the machine is printing, and 2) press

and check the display to see if the machine is sending or receiving a fax.)

Initializing the network interface board

Normally the network interface board (NIC) does not need to be initialized (returned to the factory default settings). In the event that you do need to intialize the board, follow the Steps 1 to 3 of the

previous procedure to access “NETWORK CONFIG SET”, press

to select “INTIALIZE THE NIC”, and then press	START/	. Press	to
	ENTER

START/

select “YES” and then press ENTER . Wait while the machine writes the

setting to the NIC board (“DO NOT POWER DOWN” will appear in the display). When the display changes to “OK”, turn off the power of the machine and then turn it back on to make the new setting take effect. (Before turning off the power, make sure the machine is not in the middle of a job: 1) check whether the machine is printing, and 2) press

and check the display to see if the machine is sending or receiving a fax.)

8

Image 12

Contents FO-NS2 Warranty Software License Page Table of Contents Troubleshooting Specifications Introduction Steps required for setup Setting the IP Address Press Menu and thenPress Enter PressRight, press . When finished, press Enter Enter the IP subnet mask. When finished, press EnterEnter the IP gateway. When finished, press Enter If you are entering a permanent IPInitializing the network interface board Printing out the Network Settings ThenMail Server and DNS Server Settings Accessing the Web page in the machineMail server and DNS server Setting Passwords Network Scanning and Sender E-mail settingsStoring Network Scanning Destinations Storing destinations in the Web Scan to FTP Hyperlink Creating personal books in the WebInformation on using Scan to Desktop Scan to E-mail Setup Until Scan to E-MAIL SET-UP is selectedTo enter a space, press To change case, pressTo clear a mistake, press DEL Press the letter keys to enter your e-mail address see Step Then pressTime display Scan to E-mail Using the E-mail Key Load the documentsPress Enter If you wish to enter a message Press to select the option you want to change, and thenPress Enter . Change the selected option as follows Press Enter . The document is scanned and transmittedSending an Image Using a Rapid Key or Speed Dial Number Sending an image using a Rapid KeyPress the appropriate Rapid Key Enter your name, press Press Enter to begin scanning and transmissionSending an image using a Speed Dial number Numeric keysIf the destination is an e-mail Press Enter . Make sure that Destination Setting is selected Press Enter . Make sure that SET is selectedEnter to complete the entry Press To select E-MAIL Editing a Rapid Key or Speed Dial number Clearing a Rapid Key or Speed Dial numberInstalling the Network Scanner Software Software ProgramsSharpdesk Desktop Document Management Software Network Scanner ToolInstalling Acrobat Reader Users Guides for Software ProgramsInstalling the software programs Setting up Network Scanner Tool Page Page Uninstalling a program Troubleshooting Problem Scan to E-mail is not successful Check SolutionError Message at the Communication Error Problem Takes a long time to send an imageProblem Cannot connect to the network Check Solution Error Code Table Description of the ErrorPage Warranty Sharp Corporation