Bosch Appliances UPH-2D, UPH-Z Connecting the Power Supply, That the disconnecting switch is open

High Speed Pan/Tilt SystemInstalling the High Speed Pan/Tilt en 15

4.3	Connecting the Power Supply
	The base with power supply box is available in two (2) power supply voltages (24 VAC or
	230 VAC). Before proceeding with the installation, check the identification label of the prod-
	uct to verify that the device coincides with the power supply requirements.
	!	CAUTION!
		When connecting the base, make sure the power supply is disconnected and
		that the disconnecting switch is open.

When the base is opened, the power supply board appears as shown below. To connect the power supply, make the connections as seen in Figure 4.7.

Power Supply and Bi-polar Disconnecting Switch

Fig. 4.7 Connecting the Power Supply

To wire the power cable (not supplied), use Table 4.2 to attach the appropriate colored wire to the appropriate terminal.

Wire Color	24 VAC Terminal Connection
Per local Installer	Neutral
Per local Installer	Live/Active
Green/Yellow	Earth

Wire Color	230 VAC Terminal Connection
Blue	Neutral
Brown	Live/Active
Green/Yellow	Earth

Table 4.2 Terminal Connections

Bosch Security Systems Instruction Manual F01U.073.990 Version 1.0 2007.07