Bosch Appliances UPH-3D, UPH-2D, UPH-Z Creating a New Dynamic Mask, PTZ Mode Masking

56 en Configuring the SystemHigh Speed Pan/Tilt System

11.5 Creating a New Dynamic Mask

Select "Mask Changing" and an 8 x 6 grid is displayed on the screen. In the top right corner is the Mask Number, and in the bottom left corner is the text "PTZ Mode: Masking". Then pro- ceed as follows:

Press Set Shot - 1 - Enter to change from masking mode to move camera mode.

PTZ MODE: MASKING

Operate the joystick on the keyboard to move the UPH and, if necessary, operate the zoom to center the object that will be masked. In this example, we are going to mask a flower.

PTZ MODE: MOVE CAMERA

When the object is centered, press the Set Shot - 2 - Enter and press Iris Open or Close.

PTZ MODE: MOVE CAMERA

A small yellow rectangle is displayed. Operate the joystick (left, right, up & down) to enlarge the rectangle until it covers the whole flower.

PTZ MODE: MASK CHANGING

When the desired result is obtained, confirm by pressing the Iris Open or Close button. A message indicates that the mask has been saved.

PTZ MODE: MASKING

Fig. 11.27 Creating new dynamic masks

An "x" is displayed at the bottom of the parameters mode masking screen, indicating a mask has been set.

Note: The tilt angle at which you can set the mask is between -40 to +70 degrees. It is recom- mended that you set the mask size to larger than the object size (height and width) - this is to ensure masking even during pan, tilt and zoom.

F01U.073.990 Version 1.0 2007.07 Instruction Manual Bosch Security Systems