Bosch Appliances UPH-Z, UPH-2D, UPH-3D Switching On and Off, Configuring the Device

High Speed Pan/Tilt SystemSwitching On and Off en 31

8	Switching On and Off
	Systems in the UPH line are switched on by simply connecting the power supply, and
	switched off by disconnecting the power supply. When the UPH is powered up in an environ-
	ment below 0 °C, the device checks it’s internal components to make sure that they are warm
	enough to start without damage. If the internal components’ temperatures are too low, the
	OSD displays a warning message and the UPH automatically enters its de-icing mode. In de-
	icing mode the UPH is powered in an attempt to raise its internal temperature. A timer
	appears on the screen and counts down showing how much time remains for de-icing to com-
	plete.
		i	NOTICE!
			De-icing can take between 30 and 105 minutes, after which time it is ready for
			use, assuming that a safe internal temperature is reached; otherwise, it is too
			cold to safely operate the UPH and it remains off.
8.1	Configuring the Device
	The first time the UPH is switched on, make sure it is configured correctly.
	To configure the UPH, proceed as follows:
	1.	Disconnect the power supply by first tilting the device either all the way up or all the way
		down. When the UPH loses power, depending on how it is positioned, the unit may auto-
		matically tilt forward or backward. Therefore, failure in correctly positioning the UPH
		before disconnecting the power supply may result in personal injury or possible damage
		to the device.
	2.	Remove the DIP switch configuration window (see Figure 6.2).
	3.	Set the firmware update DIP switch rocker to the up position (PROGRAM. ON). See
		Figure 7.1.
	4.	Connect a monitor to the video output and power the device. After a few seconds, it is
		possible to check the settings on the monitor screen. Check these settings to verify that
		the unit is configured correctly.
	5.	After completing the check, switch off the device and re-toggle the firmware update DIP
		switch rocker to the down position (PROGRAM. OFF).
	6. Close the c window and re-connect the power supply.
			WARNING!
		!	1.	Make sure the UPH system and other components of the installation are
				closed so it is impossible to come into contact with live parts.
			2.	Make sure all parts are fastened down firmly and safely.
			3.	Make sure the power source and connecting cables are suitable for the
				power consumption of the system.
		!	CAUTION!
			Do not stay in the vicinity of the device when it is powered. There is a risk of
			crushing.

Bosch Security Systems Instruction Manual F01U.073.990 Version 1.0 2007.07