|
|
|
|
|
|
|
|
| EN |
|
|
|
|
|
|
| |
|
|
|
|
| |
|
| SIGNAL SEARCH | |||
|
|
|
|
| |
|
|
|
|
| To force a signal search: |
1.Press MODE to navigate to the SMART TRAINING PROGRAM or Stopwatch Mode.
2.Press and hold MODE for 2 seconds. The
icon 
with the outside flashing will appear to confirm a signal search is taking place. Whenever the watch is searching for the chest belt signal make sure that the chest belt is no further than 10 cm (4 inches) from the watch.
The signal search will take approximately 10 seconds. If after 10 seconds the heart icon is not flashing, then your signal search has been unsuccessful and you need to force another signal search.
See the table in the "Transmission Signal" section for more signal status information.
SETTING THE KEYPAD TONE / LIGHT MODE
You can set the watch to have the:
•Keypad "Beep" tone ON or OFF.
•Light Mode ON or OFF - see "Activating the Backlight" section.
To set these features:
1. Press MODE to navigate to the
14
SE212 English R7 OP_OK.p65 | 14 | 2006.1.6, 1:53 AM |