Kenmore 4778, 110.477, 4776 To fill dispenser compartments, To begin the wash cycle immediately

4.	Turn on the washer by selecting	POWER. Select	one of the
	cycles by turning the cycle selector. The indicator light for the
	selected cycle will illuminate. When you are selecting a wash
	cycle, the preset modifiers (Soil Level, Wash Temp, and Spin
	Speed) for the cycle will illuminate. Selectable option settings
	will glow amber. If an option or modifier is unavailable with
	the selected cycle, the light will not illuminate. The preset
	settings provide the recommended fabric care for the
	selected cycle. The display shows the estimated time
	remaining. See "Cycles."
5.	Select the desired OPTIONS. Not all Options are available
	with all cycles. See "Options."
6.	Select the desired MODIFIERS.	Not all Modifiers	are available
	with all Cycles and Options. See "Modifiers."
7.	If desired, select the CYCLE SIGNAL. The signal		is helpful
	when you are washing items that should be removed from the
	washer as soon as it stops. Select LOUD, SOFT, or OFR
8.	To begin the wash cycle immediately
	Select and hold START (for approximately 1 second).
	• If you do not select START within 5 minutes of choosing
	a cycle, the washer automatically shuts off.
	• When the wash cycle is complete, the CLOTHES CLEAN
	status light glows, the door unlocks, and the wash load
	can be removed from the washer. The washer powers
	down automatically 60 minutes after the cycle is
	complete and the CLOTHES CLEAN light goes off.
9.	To begin the wash cycle later
	Select Delay Start until the desired delay time (in hours)
	shows in the Estimated Time Remaining display. Select

Choosing the Right Detergent

Use only High Efficiency detergents. The package for this type of detergent will be marked "HE" or "High Efficiency." This wash system, along with less water, will create too much sudsing with a regular non-HE detergent. Using regular detergent will likely result in washer errors, longer cycle times, and reduced rinsing performance. It may also result in component failures and noticeable mold or mildew. HE detergents are made to produce the right amount of suds for the best performance. Follow the manufacturer's instructions to determine the amount of detergent to use.

Use only "HE" High Efficiency detergent.

To fill dispenser compartments

1.Pull out the dispenser drawer.

2.Add the desired laundry product to the proper compartment.

3.Push in the dispenser drawer slowly and completely (to avoid a spill).

START. The countdown to the wash cycle will show in the

display window, and the button indicator will blink until the

cycle begins.

IMPORTANT: When delaying a cycle, use only powdered

detergents in the main wash compartment since liquid

detergents may seep out of the compartment during Delay

Start, before the wash cycle begins.

Your new washer has a dispenser drawer with four separate compartments for your laundry products--one is for high

efficiency detergent, one is for liquid chlorine bleach, one is for liquid fabric softener, and one is for oxygen based stain fighters or color-safe bleach. Laundry products are diluted and dispensed

C

D

E

F

automatically at the proper time during the wash cycle, making it unnecessary for you to return to the washer during the cycle to add them.

It is normal for small amounts of water to remain in the dispensers when the wash cycle is complete.

Do not put laundry products directly into the wash tub. Always use the proper dispensers when adding laundry products.

Dispenser

A. Dispenser release lever

B. Oxygen based stain fighter / color-safe bleach compartment

C. Detergent type selector

D. High Efficiency "HE" detergent compartment E. Chlorine bleach compartment

F. Fabric softener compartment

13