English
MANUFACTURED (MOBILE) HOME INSTALLATION
1.Dryer MUST be exhausted outside (outdoors, not beneath the manufactured home) using metal ducting that will not support combustion. Metal ducting must be 4 inch (10.16 cm) in diameter with no obstructions. Rigid metal duct
is preferred.
2.If dryer is exhausted through the floor and area beneath the manufactured home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure.
3.When installing a gas dryer into a manufactured home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet.
4.This dryer MUST be fastened to the floor using P/N 0030807988 Manufactured Home Installation Kit. Follow the instructions supplied with the kit.
5.Refer to previous sections for other important venting requirements.
6.Installation must conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24
DO DON’T
DO DON’T
DO DON’T
12