5) With finger tip, gently push and turn bulb to unlock.
NOTE: A piece of tubing with an inside diameter the size of the bulb may assist in bulb removal and replacement.
6)To install new bulb, reverse Step #5 thru Step #2. (Refer to previous page [page 73].)
7)Reestablish electrical service to the dryer.
h. End of Cycle Light Replacement
1) Discontinue electrical service to the dryer.
2) Loosen and remove the cap screw on the top of the cap.
3) Remove the cap.
4)Loosen and remove the screw going into the lens.
5)Twist out lens and remove bulb/light.
6) To install new bulb, reverse Step #5 thru Step #2.
7)Reestablish electrical service to the dryer.
i.Tilt Switch Replacement
1)Discontinue electrical service to the dryer.
2)Remove the base panel from the left hand side of the dryer.
CAUTION: DO NOT PLACE HANDS BETWEEN THE DRYER BASE AND THE TUMBLER (Basket/Drum) SECTION. SERIOUS INJURY CAN RESULT.
3)Unscrew tilt switch.
4)Loosen and remove the two (2) screws securing the junction cover.
5) Remove the junction cover.
6)Mark each wire for proper replacement.
7)Remove wires from terminal.
8) Loosen and remove the two (2) mounting screws.
9) Loosen and remove cord grip cap.
10) Remove cord grip.
74