Heat Reclaimer - the dryer is equipped with a pneumatically operated heat reclaimer, which when open, will recirculate approximately fifteen percent (15%) of the dryers' exhausted air. The heat reclaimer damper is closed until ignition of flame has been established.
a. Heat Reclaimer Piston Replacement
1) Discontinue electrical service to the dryer.
2) Discontinue the air supply to the dryer.
3) Remove the
4) Remove the set screw from the clevis rod.
5) Remove the clevis rod from the piston.
6) Measure the distance between the adjustment nut and adjustment plate for correct piston stroke.
7)Remove the eight (8)
8)Remove the heat reclaimer adjustment plate.
9)Remove the air lines from the top and bottom of the piston.
10)Remove the 1/4" x 1/4" M.P.T. elbow from the top and bottom of the piston.
11)Remove the
12)Remove the heat reclaimer base pin from the heat reclaimer piston.
13)Remove the heat reclaimer piston from the eye bracket.
14)To install new heat reclaimer piston, reverse Step #13 thru Step #3.
15)Reestablish the air supply to the dryer.
16)Reestablish electrical service to the dryer. b. Heat Reclaimer Adjustment.
1)Discontinue electrical service to the dryer.
2)Loosen the heat reclaimer nuts on ALL four (4) corners of the heat reclaimer piston.
67