Lowrance electronic LMF-200 manual To unconfigure a Suzuki Engine Interface

6.Select the desired engine and press MENU. You will be taken back to the Bus Devices list where the engine interface will be shown with its new configuration.

NOTE:

If the engine interface you just configured is not shown on the Bus Devices the list, you will have to refresh the list. Let the Bus Devices list time out, then access it again.

To unconfigure a Suzuki Engine Interface:

The unconfigure command (Unset Engine) allows you to set a Suzuki Engine Interface back to its original unconfigured status. Unconfiguring an interface also will allow you to change the engine model selected during configuration.

Unset Engine:

1.Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press MENU.

2.Highlight B. DEVICES (Bus.Devices) and press MENU. The Bus Devices list will appear.

3.Select the engine Interface you want to unconfigure and press MENU.

4.Highlight UNSET ENGINE and press MENU which will launch the following message: Hit Menu to Unset Dev Name.

5.Press MENU and you will be taken back to the Bus Devices list.

To reconfigure a Suzuki Engine Interface:

The Change Engine command is used to switch the current configuration of a Suzuki Engine Interface with the configuration from a different engine. Change Engine, however, will only appear on your LMF-200 menu if you are using an engine-tank configuration that includes multiple engines. If all engine interfaces on your vessel are configured, you will have to unconfigure an interface to free up its configuration name (Port, Center, Starboard).

If all three engine interfaces are configured, which means there is no name configuration available, follow the first set of instructions. If the desired configuration name is available, follow the second set of instructions.

Change Engine (Active only with multiple-engine setting)

The steps below show how to switch the configuration name of an engine interface from the Port engine to the Starboard engine.

45