2.Highlight B. DEVICES and press MENU. After a few moments, the Bus Devices list will appear, showing all LowranceNet devices detected on the network.
3.Select the desired fuel flow and press MENU. Highlight RESET, press MENU and a message will be displayed: Hit Menu to Rst Values.
4.Press MENU to reset the fuel flow values to default settings.
NOTE:
By resetting values from the configuration menu, ONLY the device selected from the Bus Devices list will be set back to its defaults. When you Reset Values, the calibration and configuration settings of the device are set back to factory defaults.
EP-15 Fluid Level Configuration
The
On the Bus Devices list, the fuel tanks will be displayed as F. Tnk (P)
—Port, F. Tnk (C) — Center and F Tnk (S) — Starboard. If you have one tank it will be shown as Fuel Tank.
Other tanks will be displayed as BlkW Tnk (Blackwater), FrW Tnk (Freshwater), O. Tnk (Oil), LW Tnk (Live Well) and WtW Tnk (Waste Water/Gray Water). If you have more than one of particular tank type, it will be followed by a tank number like the following examples: FrW Tnk1, BlkW Tnk2, LW Tnk3, etc. A fluid level configured for oil will be shown as O. Tnk (P), O. Tnk (C) or O. Tnk (S).
NOTE:
The Fuel Remaining Source must be set to fluid level for the unit to correctly display fuel level information. It is set to Fuel Flow by default.
Fluid Level menu
The Fluid Level menu contains the following features: Configure, Unconfigure, Reconfigure, Level Warning, Calibrate, Reset Cal and Reset Values. Calibration and Reset Calibration will be addressed in the calibration portion of this section.
Caution
If you configure your fluid level for fuel, you will NOT be able to get a fuel range reading. Fuel Range will NOT be calculated with a fluid level sensor. It will only be calculated with an engine interface,
39