Intel 273246-002 manual Setting up the Evaluation Board, Evaluation Board Jumpers and Connectors

Getting Started

2.5Setting up the Evaluation Board

Once you have gathered the hardware described in the last section, follow the steps below to set up your evaluation board. This manual assumes you are familiar with basic concepts involved with installing and configuring hardware for a personal computer system. Refer to Figure 2-1for locations of connectors, jumpers, etc.

1.Make sure you are in a static-free environment before removing any components from their anti-static packaging. The evaluation board is susceptible to electro-static discharge damage; such damage may cause product failure or unpredictable operation.

2.Inspect the contents of your kit. Check for damage that may have occurred during shipment. Contact your sales representative if any items are missing or damaged.

Caution: Connecting the wrong cable or reversing the cable can damage the evaluation board and may damage the device being connected. Since the board is not in a protective chassis, use caution when connecting cables to this product.

Figure 2-1. Evaluation Board Jumpers and Connectors

PCI	AGP Connector		USB	Keyboard (Top)	COM1 (Top)/
Connectors				/Mouse	COM2
ISA						Parallel Port
			J2
Connectors						LEDs
			J1	J3	D1
J5	J6			J4
					D2	ATX Power
	J7	J8	J9			Connector

J12

J14

J13

J15

Floppy

J11

Connector

J17

J18

Processor

Assembly

J20

J21

J21

J22

J22

U12

U13

U11

ITP

J23

Debugger

Post

Port

Code

JP2

J2

Debugger

IDE2

IDE1

JP2

JP3

J24

Battery

JP2

J24

J23

IDE Connectors

SDRAM

Special Mounting Holes

DIMM Slots

Celeron™ Processor Development Kit Manual 2-5