Useful Telephone Settings
Base unit settings
Adjusting ringer volume
1Press $(centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
30).
4Press ,2 times.
5Push the joystick up or down repeatedly to select the desired volume.
6Press ,.
7Press {ih}.
Call Options
Changing the recall mode
Change the recall mode, if necessary, depending on the requirements of your service provider or PBX.
“Type 1”: 100 ms
“Type 2”: 600 ms
“Type 3”: 200 ms
1Press $(centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
30).
4Select “Call Option”, then press
,.
5Select “Recall”, then press ,.
6Select the desired setting, then press
,.
7Press {ih}.
Setting pause length
Change the pause length, if necessary, depending on the requirements of your service provider or PBX.
“Short”: 3 sec.
“Long”: 5 sec.
1Press $(centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
30).
4Select “Call Option”, then press
,.
5Select “Pause Time”, then press
,.
6Select the desired setting, then press
,.
7Press {ih}.
Storing/changing emergency numbers
These settings determine which phone numbers can be dialled while the call bar feature is on (page 25).
1Press $(centre of joystick).
2Select u, then press ,.
3Enter “0000” (default base unit PIN). LIf you changed the PIN, enter it (page
30).
4Select “Call Option”, then press
,.
5Select “Emergency Call”, then press
,.
6Select a memory location, then press
,.
LIf the memory location already contains an emergency number, the number is displayed.
7Enter/edit the number, then press ,.
8Press {ih}.
Note:
LThe default setting for emergency numbers are stored in the first 3 memory locations. It is recommended that you do not overwrite these numbers.
29