Panasonic KX-TG1840NZ operating instructions Redial the number manually

Page 56

Useful Information

Problem

Cause & solution

Noise is heard during a call.

LYou are using the handset or base unit in an area

 

with high electrical interference. Locate the handset

 

and base unit away from interference sources, such

 

as antenna and mobile phones.

 

 

The handset/base unit stops

LDisconnect the AC adaptor and turn off the

working while being used.

handset. Connect the AC adaptor, turn on the

 

handset and try again.

 

 

While storing an entry in the

LA call is being received. To answer the call, press

phonebook or assigning a one

{C}. Programming will be cancelled. Start again.

touch dial, the handset starts to

 

ring.

 

 

 

Pressing {R} does not

LThe redialled number was more than 24 digits long.

display/dial the last number dialled.

Redial the number manually.

 

 

The handset beeps intermittently

LFully charge the batteries (page 10).

and/or 7 flashes.

 

 

 

I fully charged the batteries, but

LClean the charge contact and charge again (page

7 still flashes.

10).

 

LIt is time to replace the batteries (page 11).

 

 

Caller information is not displayed.

LYou must subscribe to Caller ID service.

 

LYour unit is connected to a telephone line with

 

ADSL (JetStream) service. We recommend that

 

you contact your ADSL service provider to have an

 

ADSL Splitter installed. We do not recommend the

 

use of generic ADSL filters.

 

 

While viewing caller information,

LDo not pause for over 1 minute while searching.

the display returns to standby

 

mode.

 

 

 

I cannot set call restriction.

LCall restriction can be set using handset 1 only. If

 

you have multiple handsets, you can confirm which

 

handset is handset 1 by pressing {x} and {1} on

 

the base unit. Handset 1 will start ringing.

 

 

I cannot register a handset to a

LThe maximum number of base units (4) are already

base unit.

registered to the handset. Cancel unused base unit

 

registrations from the handset (page 48).

 

LThe maximum number of handsets (6) are already

 

registered to the base unit. Cancel unused handset

 

registrations from the base unit (page 47).

 

LYou entered the wrong PIN number. If you forget

 

your PIN, consult your nearest Panasonic service

 

centre.

 

LLocate the handset and the base unit away from

 

other electrical appliances.

 

 

56

Image 56
Contents Model No. KX-TG1840NZ Introduction Feature highlights Useful Information Additional/replacement accessories Accessory informationIncluded accessories Battery caution Important informationGeneral EnvironmentControls and displays ControlsDisplays Connections Base unit display iconsBattery strength Battery icon Battery installationBattery charge Setting the date and time Battery replacementTurning the power on/off Example 330 PM Making calls using the handset Redial featureOther features Voice enhancerTo erase numbers in the redial list Handset phonebook Key lockMaking calls using the base unit Button to use the recall featurePause button for PBX/long distance service users Recording a telephone conversation using the handsetTo adjust the speaker volume To redial the last number dialledAnswering calls using the handset Answering calls using the base unitHandset phonebook Adding entries to the handset phonebookCategories Finding and calling a handset phonebook entryErasing entries from the handset PhonebookOne touch dial Editing entries in the handset PhonebookErasing a one touch dial assignment Making a call using a one touch dial keyChain dial Finding and calling a shared phonebook entry Shared phonebookAdding entries to the shared phonebook Editing entries in the shared phonebook Erasing entries from the shared phonebookChanging a name, phone number, audible call Playing back an audible call announcementCopying phonebook entries Copying handset phonebook entries to other handsetCopying handset phonebook entries to the shared phonebook Copying one entryGuide to handset settings Handset settings Sub-menu Default setting MenuTime settings Ringer setupAlarm Ringer volumeNight mode Setting the start and end time for night modeTurning night mode on/off Setting the ring delay for night modeDisplay setup Selecting the standby mode displaySelecting categories to bypass night mode Changing the display languageCall options Other optionsResetting the handset to its default settings Guide to base unit settings Base unit Sub-menu Default setting Settings menuNight mode Setting pause length Changing the recall timeStoring/changing emergency numbers Selecting area codes to be deleted automaticallySetting call restriction Resetting the base unit to its default settings Changing the base unit PIN Personal Identification NumberUsing Caller ID service Category features for handset phonebookCaller list Audible call for shared phonebookViewing the caller list and calling back Editing a caller’s phone number before calling backCall minder Storing caller information into the handset phonebookAnswering system Greeting messageUsing a prerecorded greeting message Using the handsetListening to messages Playing back the greeting messageListening to new/all messages Erasing all messagesKey Direct commands Direct command operation using the handsetCalling back using the handset Caller ID subscribers only Using the answering system remotely Remote operationTurning remote operation on/off Voice guidanceRemote commands Key Remote commandAnswering Default System setting Setting Turning on the answering system remotelyTurning message alert on/off Selecting the caller’s recording timeTurning call screening on/off Answering System Features Operating additional units Registering a handset to a base unitAdditional handsets Additional base unitsCancelling a handset Selecting a base unitCancelling a base unit IntercomIncreasing the range of the base unit Between a handset and the base unitFrom the base unit to a handset Between handsetsFrom a handset to the base unit Transferring a call without speaking to the handset user Wall mounting Screws Hook 108 mmAvailable character entries Character entry modesCyrillic character table P Extended 1 character table NExtended 2 character table O Problem Cause & solution TroubleshootingInitial settings Telephone Redial the number manually Answering system Specifications Index PINIndex Customer Support Centre Tel. No 272 Sales Department Copyright