Elta 4518 manual Power Connection, Getting Started, Time and Calendar Setting

02-4518-EN.qxp 12/4/06 3:02 PM Page 13

POWER CONNECTION

Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery back up system, it requires a 3 x 3V CR2025 Flat Lithium battery (Not included). Insert the battery in the battery compartment, making certain that the positive and negative (+ and -) battery terminals are attached to the corresponding terminals on the plate in the battery compartment. If an AC power failure occurs, the clock automatically switches to the battery power supply, the clock and timer memory continue running. When the AC power resumes, the clock switches back to AC again.

GETTING STARTED

Press the reset button (17) locates on the back of unit after AC plug in.

-The unit will display full segment for 2 seconds, then it will enter the normal mode.

-Display will lighten up.

1. TIME AND CALENDAR SETTING

A.Setting Time and Calendar - Press Mode Set button (1) in normal mode and keep depress over 2 second to enter Time Set mode, after enter the setting mode, press Mode Set buton (1) to change the mode cycle as follows :

Normal - Year - Month - Day - 12/24H - RTC Hour - RTC Min - Normal Action (during data adjustment) :

-Press

-Press

button (7) to adjust data forward. button (8) to adjust data backward.

-Keep depress

or

button for 2 second to enable auto forward.

a. Year Set Mode
Initial Value	: 2006
Year Range	: 2000 to 2099

Display Show Year Set Mode

b. Month Set Mode

Display Show Month Set Mode

c. Day Set Mode

Display Show Day Set Mode

Remark: Weekday will recalculate when year, month or day is adjusted.

d. 12/24H Set Mode

Display Show 12/24H Set Mode (Select 12H)

Display Show 12/24H Set Mode (Select 24H)

￿13.