Tripp Lite 3-Phase 20kVA, 30kVA Operation Special Conditions, LCD Display Select Button

Operation (Normal Conditions) (continued)

LCD DISPLAY SELECT BUTTON

Momentarily press the “SELECT” button on the front panel to browse through different power readings on the LCD Display.

BYPASS OUTPUT

R:XXXV R: XXX.XV

S:XXXV S: XXX.XV

T:XXXV T: XXX.XV

(Bypass & Output Voltage)

Press "SELECT" Button

OUTPUT	LOAD
R: XXX%	XXX.XA
S: XXX%	XXX.XA
T: XXX%	XXX.XA

(Output Load & Current)

Press "SELECT" Button

MAINS	INVERTER
R: XXXV	R: XXX.XV
S: XXXV	S: XXX.XV
T: XXXV	T: XXX.XV

(Mains & Inverter Voltage)

Press "SELECT" Button

BYPASS: XX.X Hz

MAINS: XX.X Hz

OUTPUT: XX.X Hz

INVERTER: XX.X Hz

(Bypass, Mains, Output & Inverter Frequency)

Press "SELECT" Button

CHARGE FLOATING

CHARGER: XXX.XV

BATTERY: XXX.XV

BATTERY: XXX.X%

(Charger Mode, Charger/Battery Voltage & Battery Percentage)

Press "SELECT" Button

SN:	XXX
DC BUS:	XXV - XXV
TEMP:	XXX.X˚C
VERSION:	XXX

(Serial Number, DC BUS Voltage, Temperature & Firmware Version)

		Press "SELECT" Button
ON:	UPS START
OFF:	UPS BYPASS		(Button Functions)
SEL:	UPS MESSAGE
ENT:	SET UPS
		Press "SELECT" Button

Operation (Special Conditions)

OPERATION ON BYPASS—VOLTAGE OUT OF RANGE

While in Bypass Mode, the UPS monitors the input voltage, which on Bypass equals the output voltage. If the output voltage passes out of an acceptable range (between 15% higher and 20% lower than nominal), the UPS displays the condition on its LCD and stops supplying output power to its load. If power levels return to an acceptable level, the UPS resumes supplying power to the load, and its LCD reports that output voltage was too high or too low at one time, but has returned to nominal.

Bypass Voltage Condition	LCD Display Message
>15% Higher than Nominal	BYPASS HI NO O/P
>20% Lower than Nominal	BYPASS LO NO O/P
Was Too High, Now Nominal	BYPASS WAS HI
Was Too Low, Now Nominal	BYPASS WAS LO

8