English
6.Never reach around the saw blade.
7.Never touch any moving parts, including the blade, while the saw is in use.
8.Never remove any safety devices or blade guards; use of the tool without them would be hazardous.
9.Never lock the saw blade guard; always confirm that it slides smoothly before using the tool.
10.Never damage the power cord of the tool.
11.Never attempt to move a
12.Never use the POWER TOOL if the starting switch does not turn on and off properly.
13.Never use the POWER TOOL if the plastic housing or the saw blade guard is cracked or deformed.
14.Never use the POWER TOOL near flammable liquids or gases because sparking can cause an explosion.
15.Never clean plastic components with solvents because the plastic may dissolve.
16.Never operate the table saw unless the saw blade guard is in place.
17.Never raise the saw blade guard from the workpiece until it has first come to a complete stop.
18.Never use abrasive type saw blades on this table saw.
19.Never perform any operation “freehand” which means using your hands to support or guide the workpiece. Always use the rip fence or the miter gauge to position and the work.
20.Never stand or have any part of your body in line the path of the saw blade.
21.Never reach behind or over the cutting tool with either hand for any reason.
22.Never use the rip fence as a cut off gauge when cross cutting.
23.Never attempt to free a stalled saw blade without first turning the saw off.
24.Never cut metals or materials which may make hazardous dust.
25.Never cut ferrous metals or masonry.
WARNING
FOR YOUR OWN SAFETY READ THIS INSTRUCTION MANUAL BEFORE OPERATING THE TABLE SAW
1.Always wear eye protection when using the table saw.
2.Always use saw blade guard and spreader for every operation for which it can be used, including all through sawing.
3.Always keep hands out of the path of the saw blade.
4.Always use a push stick when required.
5.Pay particular attention to instructions on reducing risk of kickback.
6.Never perform any freehand operation with the table saw.
7.Never reach around or over saw blade.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
Repairs should be conducted only by a Hitachi authorized service center.
USE PROPER EXTENSION CORD
Use only
Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord. Check power cords and extension cords for loose or exposed wires and damaged insulation before using. Repair or replace as needed before using the power tool.
6