Radio signal range limitation function on/off setting (EYFLA4AR, EYFLA5AR, EYFLA5QR, EYFLA6PR)
1.Set the tool to configuration mode. (See page 11.)
2.Press the format button.
•The control panel will begin flashing.
Display: The letter “F” flashes on and off.
Battery indication lamp: The upper and lower bars of the battery flash on and off.
Display
Battery indication lamp
3.Press the format button again.
•Radio signal range limitation function on/off setting value will be displayed.
4.Press the 
and 
buttons to set radio signal range limitation function on/off.
| Radio signal |
|
| |
Display | range limitation |
| Status | |
| function mode |
|
| |
|
| Tool is operational in the | ||
C0 | OFF | absence of communica- | ||
tions with the Assembly | ||||
|
| |||
|
| Qualifier. |
| |
|
| Tool is | not operational | |
C1 | ON | in the absence of com- | ||
munications with the As- | ||||
|
| |||
|
| sembly Qualifier. | ||
Factory settings
•Radio signal range limitation function setting: C0 (OFF)
NOTE:
•For more information about how to register the tool and assembly qualifier, see the assembly qualifier instruction manual.
Initializing All Settings
Factory settings
•Torque clutch setting: “F” (torque con- trol function off)
•Interval setting: 0 (off)
•This section explains how to revert all tool settings to their default values at the time of shipment from the factory.
•The error display will be turned off.
1.Set the tool to configuration mode. (See page 11.)
2.Press the format button.
•The control panel will begin flashing.
Display: The letter “F” flashes on and off.
Battery indication lamp: The upper and lower bars of the battery flash on and off.
Display
Battery indication lamp
3.Press the OK button to accept the select- ed setting.
•The control panel will stop flashing and light up.
Checking Tool Settings
•This section describes how to have the tool display current settings for approx- imately 3 seconds when the tool is stopped.
•You cannot check tool settings when the control panel is turned off. First, engage the switch briefly to reactivate the display.
Checking the sung point detection setting
1.Press the torque set button.
•Control panel display
Display: The torque set lights up.
Battery indication lamp: The upper and mid- dle bars of the battery flash on and off.
Checking the interval
1.Press the interval set button.
•Control panel display
Display: The interval set lights up.
Battery indication lamp: The middle bar of the battery flashes on and off.
- 14 -