Porter-Cable N028591, C7501 instruction manual Typical

NOTE: Compressed air from oil lube air compressors will contain water­ condensation and oil mist. Several drains, traps and filters will be needed to supply air without water (including aerosols) or oil to spray equipment, air tools and accessories requiring filtered air. Always read the instruc­tions­ for the air tools and accessories being used.

•Use pipe that is the same size as the air tank outlet. Piping that is too small will restrict the flow of air.

•If piping is over 100' (30.5 m) long, use the next larger size.

•Bury underground lines below the frost line and avoid pockets where condensation can gather and freeze. Apply pressure before underground lines are covered to make sure all pipe joints are free of leaks.

•A flexible coupling is recommended to be installed between the globe valve/ air discharge outlet and main air distribution line to allow for vibration.

•A separate regulator is recommended to control the air pressure. Air pressure from the tank is usually to high for individual air driven tools.

•DO NOT install lubricators between the tank and any spray equipment, air tool or accessory requiring oil-free filtered air.

•Drain all traps, filters and dirt legs daily.

AIR FLOW	FEEDER LINES SLOPE	AIR FLOW
	WITH AIR FLOW

MAIN DISTRIBUTION AIR LINES
Slope pipe in direction of air flow.					DRAIN
Water condensate flows along			AIR USAGE		LEGS
bottom of pipe to drain legs,			LINES
preventing it from entering feeder
lines.					DRAIN
					VALVES
	.01 MICRON	5 MICRON		FILTER /
	FILTER	FILTER		MOISTURE
				TRAP
			DIRT
			LEGS
SPRAY					REGULATOR
GUN
			DRAIN		LUBRICATOR
REGULATOR			VALVES
BALL
FILTER
					AIR
					TOOL
FILTER /	FOR BEST PERFORMANCE		FLEXIBLE
	the distance between the
MOISTURE	compressor and the		COUPLING
TRAP	moisture trap should be as				GLOBE VALVE /
	long as possible
					AIR DISCHARGE
				AIR	VALVE
DRAIN
	TYPICAL			COMPRESSOR
VALVE
COMPRESSED AIR
DISTRIBUTION
	SYSTEM				DRAIN
					VALVE
	RISK OF BURSTING. ALWAYS USE
	METAL PIPING AND FITTINGS.

10 - ENG