⬤Do not drive nails on the top of other nails or with Nailer at too steep of an angle; nails can ricochet and hurt someone.
⬤Do not drive nails into thin boards or near corners and edges of workpiece. Nails can be driven through or away from workpiece and hit someone.
⬤Never drive nails from both sides of a wall at the same time. Nails can be driven into and through the wall and hit a person on the opposite side.
⬤Never use Nailer which is defective or operating abnormally.
⬤Do not use Nailer as hammer.
⬤Disconnect battery and fuel cell from Nailer when:
1)it is not in use;
2)leaving work area;
3)moving it to another location; and
4)handing it to another person.
⬤Be careful of unwanted fastener.
If pulling the trigger more when not driving nail at the temperature below 30°F (0°C), an wanted fastener will be driven.
This Nailer is equipped with a FULL SEQUENTIAL ACTUATION MECHANISM.
Explanation of FULL SEQUENTIAL ACTUATION MECHANISM nailing operation;
First, press the push lever against the workpiece; next, pull the trigger to drive a nail.
The machine employs a preventive mechanism for unloaded operation.
The machine enters a state where the push lever cannot be pushed up. This takes place when the magazine is not loaded with nails or when the remaining number of nails becomes less than 8 or 9.
CAUTION
⬤Use caution not to throw the push lever tip onto wood when the push lever cannot be pushed up.
METHODS OF OPERATION
CAUTION
⬤Squeeze the trigger when drive a nail, otherwise the piston can not return correctly.
⬤Make sure the nailing depth when the temperature is above 85°F (30°C) or below 50°F (10°C).
This Nailer is equipped with the push lever and does not operate unless the push lever is depressed (upward position).
It is intermittent operation (Trigger fire) only.
1Position the nail outlet on the workpiece with finger off the trigger.
2Depress the push lever firmly until it is completely
depressed.
3Pull and squeeze the trigger to drive a nail.
4 Remove finger from the trigger.
To continue nailing in a separate location, move the nailer along the wood, repeating steps 1 - 4 as required.
English
3
2 
Trigger
Push lever
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth, be sure that the Nailer is always held firmly against the workpiece.
If nails are driven too deep or shallow into the workpiece, adjust the nailing in the following order.
1Remove the fuel cell and the battery from the Nailer.
Fuel cell
Battery
2Loosen the bolt with wrench.
3If nails are driven too deep, move the push lever to forward.
Push lever
If nails are driven too shallow, move the push lever to backward.
4Stop moving the push lever when a suitable position is reached for a nailing test.
— 17 —