BM 2610034445
7.Align other end of rubber cord with guide sleeve. Repeat steps for 2nd rubber cord (Fig. 21).
8.To ensure proper alignment of rubber cords, guide sleeves must be properly installed. See (Figure 22) for correct orientation.
9.Rubber cord must be properly installed. See (Figure 23) for correct orientation. Any twisting of the cord will impair performance.
10 Replace Driver
assembly and then push forward into tool (Fig. 24).
11.NOTE: To properly install driver sub- assembly, the driver blade and guide rails will need to be repositioned into correct placement (Fig. 25). See following steps for more detail.
*Tip: Place tool on nose (firing position, battery removed) for better view.
12 Align driver blade (A) by inserting blade tip into blade shaft opening (B) (Fig. 26).
FIG. 21 |
FIG. 22
FIG. 24
FIG. 25 |
FIG. 23 | CORRECT |
| |
| INCORRECT |
FIG. 26 |
B |