Bosch Power Tools FNH180K-16 Replacing Driver Blade, To replace drive blade, follow steps below

BM 2610034445 03-14_FNH180 3/27/14 11:52 AM Page 21

13.As driver blade is inserted into blade opening, align both guide rails into rail holes on both sides (Fig. 27).

14.Securing driver sub-assembly to tool. Frame assembly should align with mounting holes for pins. Insert both pins and push in (Fig. 28).

15.Pins should stick out an equal length from both sides (Fig. 29).

16 Place metal top cap back on tool. Replace

(3) allen screws (Fig. 30).

FIG. 27

FIG. 28

FIG. 29

FIG. 30

Replacing Driver Blade

1.Remove metal cap. Using 3mm hex wrench, remove 3 screws and set aside (Fig. 31).

To replace drive blade, follow steps below:

2.Remove drive block pin #1 by pushing on one side. Pull on other end to remove. *TIP* 16ga finish nail can be used to slide pin out (Fig. 32).

FIG. 31	FIG. 32
	-21-