Dukane iQ Series user manual Connecting Cables Quick Start Guide, AC Power Inlet

iQ Series, Ultrasonic Hand Held Systems User’s Manual

Connecting Cables - Quick Start Guide

Complete the basic connections as shown below:

•AC Line Input

•HAND PROBE Connector

•Grounding Stud

•AC Power Cord Connection

Step 1. Attach the female end of the power cord (200/240V only) to the generator’s power inlet connector - A in Figure 3-1.

(The 100/120V model’s power cord is permanently attached to the unit.)

Step 2. Attach the hand probe’s cable connector to the generator’s HAND PROBE connection. - B in Figure 3-1. Secure the connector to the system us- ing the two jack screws attached to the connector hood.

Step 3. Ground the generator chassis with a user–supplied 14-Gauge wire. Attach one end to the grounding stud - C in Figure 3-1. Attach the other end to the nearest grounded metal pipe or equal earth ground.

Step 4. Attach the male end of the power cord to a suit- able line receptacle.

Optional Connections - See Page 14 for information about the rear panel OUTPUTS connector.

NOTE

AC Power Inlet

Depending on your generator model, line voltage required for the generator is either 100-120 VAC at 50/60 Hertz or 200-240 VAC at 50/60 Hertz.

The unit has a power switch, and is pow- ered ON whenever the AC line power is live and the switch is in the ON position as shown in Figure 3-2 below.

Push ON

Push OFF

Figure 3-2Rocker-style Power Switch/Circuit Breaker

Power Cord Strain Relief

	B
HAND PROBE
OUTPUTS	A
C
	Optional
	Connections

HAND PROBE

C

OUTPUTS

REAR VIEW	REAR VIEW
100/12O VOLT MODEL	200/24O VOLT MODEL

Figure 3-1Generator Detail - Rear Views

Page  12 Dukane Manual Part No. 403-577-01