Dukane iQ Series Navigating Through the Modes, Navigate to Time Mode, Navigating to Manual Mode

iQ Series, Ultrasonic Hand Held Systems User’s Manual

Navigating Through the Modes

When the generator is first powered up, the default operating mode is Manual, and Manual Weld is shown at the top of the display as shown in Figure 5-1.

Navigate to Time Mode

1.Follow the sequence shown in the figures to the right to navigate from Manual mode to Time mode.

In Manual mode, press the TIME key (Figure 5-2).

2.The phrase, Enter Changes Mode, means when the ENTER key is pressed, the mode will change. So press the ENTER key, and the Weld by Time screen seen in Figure 5-3 appears.

3.Set the time.

Use the and the + - keys to move the cursor and to set the digits for the weld time you want.

4.Press the ENTER key to accept the time that has been set (Figure 5-4).

Press the CANCEL key if you decide not to set the time.

NOTE

Navigating to Manual Mode

Set Time or Energy (depending on mode) to OFF, and press ENTER.

This will put you back in Manual mode.

Alternately:

Find an empty setup. Press SETUP. Press ENTER.

A pop-up screen about defaults appears.

Setup #1Empty

Load Defaults?

YES NO

Select YES to load the default operating mode which is Manual, and you can weld using the Manual mode.

Manual Weld

Weld Time 0.000 S

Weld Energy 0 J

#2

Figure 5-1Manual Weld Mode

TIME key

Manual Weld

Weld By Time

OFF

Enter Changes Mode

Figure 5-2Navigate to Time Mode

ENTER key

Weld by Time
Weld By Time	Set the time.
OFF S

Press Enter To Accept

Press Cancel To Abort

Figure 5-3Time Weld Mode - 1

Weld by Time

Weld Time	ENTER key
0.500 S
Press Enter To Accept
Press Cancel To Abort

Figure 5-4Time Weld Mode - 2

Page  24 Dukane Manual Part No. 403-577-01