P
C
Fig. 18
10.Insert the front end of the splitter (P) Fig. 18 inside the splitter mounting bracket behind the splitter fastener plate and the screw (C). Push the splitter down as far as possible, making certain that the bottom edge of the splitter (P) is parallel with the table surface. Tighten the screw (C). Fasten the splitter and the blade guard assembly (P) Fig. 19 to the bracket (M), using a
11.IMPORTANT: The splitter (P) Fig. 20 has a notch (W) in the top edge. Raise the front of the blade guard (G) Fig. 25, until the rear edge of the guard slips into notch (W) of the splitter. This notch keeps the blade guard in the raised position.
12.Attach the saw blade with the teeth pointing down at the front of the saw table (Fig. 21). Attach the outside blade flange and arbor nut (X). With the open end wrench (Y) on the flats of the arbor, tighten the arbor nut by turning the
13.Use a straight edge (A) Fig. 22 to align the splitter (P) with the saw blade (B). Use a square (C) Figs. 23 and 24 to check the 90 degree angle of the saw blade and splitter to the table surface. When all alignments are correct, tighten the hardware (D) Fig. 24.
P
B
A
Fig. 22
P
O
V 
M
Fig. 19
G
P
W
Fig. 20
Y 
P
Z |
| Fig. 21 |
|
|
|
B
C
Fig. 23
12