DeWalt 36-L31X, 36-L53L, 36-L51X, 36-L51L instruction manual Motor Cover

P

C

D

Fig. 24

14.Hold the blade guard and lower the saw blade. Install the table insert (E) Fig. 25 in the opening of the saw table.

15.Place a straight edge (B) across the table at both ends of the table insert (Fig. 26).

Ensure that the table insert (A) is level with the table.

If an adjustment is necessary, turn the adjusting screws (C) with the 1/8" hex wrench.

MOTOR COVER

NOTE: If your Unisaw uses an LVC Starter Box, attach the two bottom spring clips to the motor cover.

1.Align the hole in the motor cover clip with the hole in the motor cover. Place a 13/64" flat washer on a 10-32

x1/2" screw (A) Fig. 27. Insert the screw through the hole in the motor cover clip and thread the screw (A) in the tapped hole in the motor cover. Repeat this process for the remaining motor cover clip.

2.Place the motor cover in the opening of the Unisaw (Fig. 28). Place the rear motor cover clips inside the motor opening. Push the front of the motor cover until all four motor cover clips are engaged.

3.Align the hole (B) Fig. 29 in the bottom of the motor cover with the hole in the side of the saw cabinet. Place

a1/4" flat washer on a 1/4-20 x 5/8" hex-head screw. Insert the screw through the hole in the motor cover. Thread the screw in the hole in the side of the motor cabinet. Tighten securely.

NOTE: To detach the motor cover, remove the 1/4-20 x 5/8" hex-head screw (B) Fig. 29, and push the motor cover to one side. This will depress the clips and you can remove the cover.

Fig. 28

E

Fig. 25

C

A B

Fig. 26 C

A

Fig. 27

B

Fig. 29

13