BM 2610021316
Unpacking And Checking Contents
!WARNING Before moving the saw: lock the miter lock knob in 45° posi-
tion. lock head assembly in the down position.
Never carry the tool by the cord or head assembly power switch handle.
The CM12 Miter Saw is shipped complete in one box.
1.Separate all parts from packing materials and check each one with the “Table of Loose Parts” to make sure all items are accounted for before discarding any packing material.
2. Table of Loose Parts:
Workpiece Clamp - Used to clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Multi purpose “L” wrench - Should be stored on the left rear base.
Miter Lock Knob - Used to lock the table at desired miter angle.
If any parts are missing, do not ! WARNING plug in power cord or turn the
switch on until the missing parts are obtained and are installed correctly.
Assembly
Tools Needed for Assembly And Alignment
| Combination Square | Multi Purpose “L” Wrench 6/4mm | ||||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Combination Square Must be True
Draw Light
Line on Board
Along this Edge
Should be no Gap or Overlap when Square is Flipped Over in Dotted Position
Straight Edge of Board 3/4" Thick This Edge Must be 
Perfectly Straight
Assembly
Removing and Installing Blades
| ! WARNING | To avoid possible injury discon- | Moving Guard Assembly |
|
| nect plug form power source | 1. Position the saw in the UP position and at 0° |
|
| ||
before performing any assembly, adjustment or | bevel. If in the DOWN position, press down slightly | ||
repairs. |
| on the saw head assembly and pull out the head as- | |
|
|
| sembly lock pin (item 36, page 8); then allow the saw |
|
|
| head to come up (See Figure 3). |