Bosch Power Tools CM12 manual Using Miter Detent System, Fasten from back of fence, Detents

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 22

Basic Saw Operations

fasten from back of fence:

Use minimum 3/4" auxiliary fence and 1/4" round head wood screws (3/4" long).

1.Drill four pilot holes through auxiliary fence and run screws from rear of metal fence.

2.Repeat test cut.

WARNING Check for interference between

!auxiliary fence and saw head componenents by performing a dry run. Fence interference can prevent proper saw operation and cause injury and/or tool damage.

FIG. 30

Auxiliary fence

Blade

Slot

				flat Head Machine
				Screws
		7"
			7-3/8"
			FIG. 31	3-1/4"
5-1/2"		7-3/8"
	3-1/4"	2-3/16"	2-3/16"	2-3/4"
			22"

Using Miter Detent System

1.Loosen the miter lock knob about 1/2 turn. (See Figure 32)

2.Grip the lock knob, and then reach down with your index finger to pull up on the miter detent lever – pull lever until it is out from the detent plate.

3.While gripping the lock knob and lever, rotate the saw’s table. Stop table rotation at the de- sired angle as indicated by the miter scale pointer.

4.Release the lever into a detent in the detent plate or at an angle between detents. If close to a detent, use the detent override feature.

5.Tighten the miter lock knob before cutting.

Detent

plate

FIG. 32

Miter lock Knob

Miter Scale	Miter
	Detent lever
pointer

Detents

-22-