Bosch Power Tools CM12 manual Miter and Bevel Settings for Standard Crown Molding Cuts

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 29

Miter and Bevel Settings for Standard Crown Molding Cuts

(When Crown Molding is lying flat on Table)

Assumptions: Molding is milled consistently. Corner is exactly 90º.

Molding Spring Angle is 38 degrees

	Miter	Bevel
	(Table)	(Tilt)
	Setting	Setting
Inside Corner
Left end (A)	(31.6) Right	(33.9) Left
Use the left end
of the cut
Right end (B)	(31.6) Left	(33.9) Right
Use the right end
of the cut
Outside Corner
Left end (C)	(31.6) Left	(33.9) Right
Use the left end
of the cut
Right end (D)	(31.6) Right	(33.9) Left
Use the right end
of the cut

Molding Spring Angle is 45 degrees

	Miter	Bevel
	(Table)	(Tilt)
	Setting	Setting
Inside Corner
Left end (A)	(35.3) Right	(30.0) Left
Use the left end
of the cut
Right end (B)	(35.3) Left	(30.0) Right
Use the right end
of the cut
Outside Corner
Left end (C)	(35.3) Left	(30.0) Right
Use the left end
of the cut
Right end (D)	(35.3) Right	(30.0) Left
Use the right end
of the cut

Ceiling	Ceiling
52°	45°
Wall 38°	45°	Wall
	45/45° Crown Molding
38/52° Crown Molding
38° Spring Angle	45° Spring Angle	Inside
		Corner

Fence

Top of Molding

Against Fence

Table

Outside Corner

-29-