BM 2610021316
Attaching Miter lock Knob | FIG. 8 |
Locate the miter gauge lock knob from among the loose parts, and thread shaft on lock knob into hole provided. (See Figure 8)
Adjustments
!WARNING Disconnect plug from power source before performing any
assembly, adjustment or repair to avoid possible injury.
NOTE: Your miter saw was completely adjusted at the factory. However, during shipment, slight mis- alignment may have occurred. Check the following settings and adjust if necessary prior to using this miter saw.
Checking 0° Bevel Adjustment
1.Lower head assembly and engage head assem- bly lock pin.
2.Rotate table to 0° miter position and lock.
3.Pull forward bevel lock lever to unlock bevel.
4.Tilt the saw assembly to the left, then rotate saw assembly to the right until you feel the stop in the vertical position. This is where the saw is currently set for 0° bevel cut.
5.Use a combination square to check blade squareness to the table. Place the square on the table and press it against the blade. If the blade does not contact the full length of the square, fol- low the calibration procedure. (See Figure 9)
Combination | FIG. 9 |
| |
Square |
|
Calibrating Blade at 0° Bevel (90° to the table) Note: Use a 1/2” (13mm) wrench for adjustment. Note: Calibrating the bevel setting automatically calibrates the 33.9° left stop and
1.Lower head assembly and engage head assem- bly lock pin.
2.Pull the bevel lock forward to unlock the head assembly.
3.Locate the bevel stop bolt below the bevel lock handle on the right side of the bevel post. This bolt features a lock nut. (See Figure 10)
FIG. 10
Bevel lock
Handle
Bevel Scale
pointer
Bevel Scale
lock Nut 
Bevel Stop Bolt
-2° Bevel Stop
Right
4. Loosen the bevel stop bolt a quarter turn and then loosen the lock nut. When this is complete you will be able to adjust the bevel stop bolt by hand.