part number Example - lock down pin (14).
Press down lightly on the operating handle and pull out the lock down pin (14), as shown in Figure 3. Gently release the downward pressure and allow the arm to rise to its full height. Use the lock down pin when carrying the saw from one place to another. Use the operating handle (1) to transport the saw or the hand indentations
(15)shown in Figure 2 after unplugging.
Specifications
Important Safety Instructions
Changing or Installing a New Saw Blade
CAUTION:
•Never depress the spindle lock button while the blade is under power or coasting.
•Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product with this miter saw.
CAPACITY OF CUT
47 degree miter left and right
47 degree bevel left: 2 degree right
0degree miter - Max. Height
45 degree miter - Max. Height
Bench Mounting
Bench mounting holes (8) are provided in all four feet to facilitate bench mounting, as shown in Figure 1. (Two different sized holes are provided to accommodate different sizes of screws. Use either hole, it is not necessary to use both.) Always mount your saw firmly to prevent movement. To enhance the tool’s portability, it can be mounted to a piece of 1/2" or thicker plywood which can then be clamped to your work support or moved to other job sites
and reclamped. NOTE: If you elect to mount your saw to a piece of plywood, make sure that the mounting screws don’t protrude from the bottom of the wood. The plywood must sit flush on the work support. When clamping the saw to any work surface, clamp only on the clamping bosses where the mounting screw holes are located. Clamping at any other point will interfere with the proper operation of the saw.
CAUTION: To prevent binding and inaccuracy, be sure the mounting surface is not warped or otherwise uneven. If the saw rocks on the surface, place a thin piece of material under one saw foot until the saw sits firmly on the mounting surface.
Removing the Blade
1.Unplug the saw.
2.Raise the arm to the upper position and raise the lower guard (2) as far as possible.
3.Loosen, but do not remove guard bracket screw (figure 4) until the bracket can be raised far enough to access the blade screw. Lower guard will remain raised due to the position of the guard bracket screw.
4.Depress the spindle lock button (19) while carefully rotating the saw blade by hand until the lock engages.
5.Keeping the button depressed, use the other hand and the wrench provided to loosen the blade screw as shown in figure 5. (Turn clockwise,
6.Remove the blade screw, outer clamp washer, and blade.
Installing a Blade
1.Unplug the saw.
2.With the arm raised, the lower guard held open and the pivot plate raised, place the blade on the spindle, and against the inner clamp washer with the teeth at the bottom of the blade pointing toward the back of the saw.
3.Assemble the outer clamp washer onto the spindle.
4.Install the blade screw and, engaging the spindle lock, tighten the screw firmly with wrench provided. (Turn counterclockwise,
| |
11 | If you have any questions, call |