Ripping
RIPPING is known as cutting a piece of wood with the grain, or lengthwise. This is done using the rip fence. Position the fence to the desired WIDTH OF RIP and lock in place. Before starting to rip, be sure:
A. Rip Fence is parallel to sawblade.
B. Riving knife is properly aligned with sawblade.
C. Antikickback pawls are functioning properly.
When ripping LONG BOARDS or LARGE PANELS, always use a work support (Fig. 62). The Bosch table saw outfeed support table
kit (TS1001, TS1002) is an ideal accessory to use for this FIG. 62 application.
BEVEL RIPPING
When bevel ripping material 6" or narrower, use fence on the right side of the blade ONLY. This will provide more space between the fence and the sawblade for use of a Push Stick. If the fence is mounted to the left, the sawblade guard may interfere with proper use of a Push Stick.
When “WIDTH OF RIP” is 6" and WIDER use your RIGHT hand to feed the workpiece, use LEFT hand ONLY to guide the workpiece … do not FEED the workpiece with the left hand (Fig. 62).
When “WIDTH OF RIP” is 2" to 6" wide USE THE PUSH STICK 1 to feed the work (Fig. 63).
When WIDTH OF RIP is NARROWER than 2" the Push Stick CANNOT be used because the guard will interfere … USE the AUXILIARY FENCE, and PUSH BLOCK.
Attach auxiliary fence 2 to rip fence with two “C” clamps (Fig. 64).
Feed the workpiece by hand until the end is approx. 1" from the front edge of the table. Continue to feed using the PUSH BLOCK 3 on top of auxiliary fence UNTIL THE CUT IS COMPLETE (Fig. 65).
FIG. 64 | FIG. 65 |
2
FIG. 63
1
3
74.