Bosch Power Tools 4100DG manual Attaching the Guard Assembly, Attaching the ANTI-KICKBACK Device

ATTACHING THE GUARD ASSEMBLY

8.With one hand, hold the front of the barrier guard assembly 4 by the metal “fork”. With the other hand, hold the guard release lever 5 up (Fig. 7).

9.Lower the rear of guard assembly and slip the cross bar 6 into the rear notch 7 on top of the riving knife 2 (Fig. 7).

10.Lower the front of the guard assembly 4 until the metal “fork” is parallel with the table (Fig. 8).

11.Press down on the guard release lever 5 until you feel and hear it snap into the locking position. Check that the guard assembly is securely connected (Fig. 8).

ATTACHING THE ANTI-KICKBACK DEVICE

12.Attach the Anti-Kickback Device 7 into the flat recessed area 8 of the riving knife 2 (Fig. 9).

13.Squeeze the compression pads 9 while nesting the device into the flat area (Fig. 9).

14.Release the compression pads such that the Anti-Kickback Device locks onto the riving knife immediately behind the guard assembly. Check that the attachment pin is securely connected into locking hole. Carefully raise and lower the pawls 10 – when letting go, the spring-loaded pawls must come down and contact the table insert (Fig. 9).

Hint: Position the Anti-Kickback Device behind the flat recessed area and slide it towards the front until it drops into the recessed area – then release the compression pins.

Note: The two attachments are independant of each other, so the Anti-Kickback Device can be attached before the Guard Assembly.

FIG. 7

4

5

7

6

2

FIG. 8 4 5

7 9

FIG. 9

9

10

8

2

28.