Bosch Power Tools 4100DG manual Table Pointer Adjustment, Adjusting The Table Insert

Table Pointer Adjustment

If an adjustment to the table pointer is necessary, loosen pointer adjustment screw 1, adjust pointer 2 and tighten screw 1 (Fig. 24).

The table pointer should always be adjusted relative to fence pointer.

1.Adjust fence pointer to (zero) - see “Rip Fence Pointer Adjustment”.

2.Slide fence to the right until it hits the stop plate on front rail and lock fence in place.

3.Look at fence pointer and note measurement on lower scale (at or near 13.5").

4.Adjust the table pointer 2 to the same reading on upper scale as that shown on the fence pointer. Both pointers must agree when fence is at this position.

Example: If fence pointer is at 13-9/16”, then table pointer should also be set at 13-9/16”.

Adjusting The Table Insert

The table insert includes four (4) adjustment screws 3 to set the height (Fig. 25). Place the insert onto the table. Place a straight edge (such as the metal ruler from a combination square) across the table top and insert top – the surfaces should be at the same level. If adjustment is necessary, use a small slotted screwdriver to rotate each set screw.

FIG. 24 1 2

FIG. 25 3

3

40.