Black & Decker BDPH200B Troubleshooting, Problem Possible Cause Possible Solution

This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary from state to state or province to province. Should you have any questions, contact the manager of your nearest Black & Decker Service Center. This product is not intended for commercial use.

LATIN AMERICA: This warranty does not apply to products sold in Latin America. For products sold in Latin America, check country specific warranty information contained in the packaging, call the local company or see the website for warranty information.

FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-800-544-6986for a free replacement.

	TROUBLESHOOTING
Problem	Possible Cause	Possible Solution
• Material runs or drips.	• Spraying too much material.	• Reduce air flow by turning
	• Spraying too slowly.	material adjustment knob.
		• Increase speed of application.
	• Spraying too close.	• Increase distance from surface.
	• Viscosity too thin.	• Check dilution
• Too much over spray.	• Sprayer too far from surface.	recommendation.
		• Reduce distance to surface.
	• Too much material being sprayed.	• Reduceair flow by turning
• Little or no material being released.	• Check valve ball stuck.	material adjustment knob.
		• Removecheck valve. Depress
		ball to loosen.
	• Spray nozzle/tip clogged.	Add lubricant. See figure Q.
		• Clean nozzles.
	• Pickup tube loose or clogged.	• Check tube.
	• Material adjustment knob setting too low.	• Increase setting.
	• Air inlet blocked.	• Clean or change air filter.
	• Material too thick.	• Check viscosity
• Materialbeing sprayedis splattering.	• Viscosity of material is too high.	recommendation.
		• Thin material per manufacturer
• Sprayer pulsates.	• Air filter clogged.	recommendation.
		• Clean or changefilter.
• Liquid comes out side of canister.	• Material in canister almost empty.	• Refill canister.
	• Lid not on square or tight enough.	• Remove lid and reattach
		squarely and evenly, then tighten
	• Paint on threads of canister and lid.	lid securely.
		• Clean threads on top and sides
		of canister and lid.

For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.

Imported by

Black & Decker (U.S.) Inc.,

701 E. Joppa Rd.

Towson, MD 21286 U.S.A.

See ‘Tools-Elec-

tric’

– Yellow Pages –

for Service &

Sales

12