WARNING: ALWAYS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
•ANSI Z87.1 eye protection (CAN/CSA Z94.3),
•ANSI S12.6 (S3.19) hearing protection,
•NIOSH/OSHA/MSHA respiratory protection.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.
•Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from face and body.
WARNING: Always wear proper personal hearing protection that conforms to ANSI S12.6 (S3.19) during use. Under some
7
conditions and duration of use, noise from this product may contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows: |
| ||||||||
V | volts | A | amperes | ||||||
Hz | hertz | W | watts | ||||||
min | minutes |
|
|
| .......... | alternating current | |||
|
|
|
| direct current |
|
|
|
| alternating or direct |
|
|
| ....... |
|
|
| .......... | ||
|
|
|
| Class I Construction | no | current | |||
|
|
|
| ||||||
|
| ............ | |||||||
|
|
|
| (grounded) | no load speed | ||||
|
| ............ | Class II Construction | n | rated speed | ||||
|
|
|
| (double insulated) |
|
|
|
| earthing terminal |
|
|
|
|
|
|
|
| ||
................ |
|
|
|
|
| ............ | |||
…/min | per minute |
|
| ............ | safety alert symbol | ||||
IPM | impacts per minute | BPM | beats per minute | ||||||
SPM | strokes per minute | RPM | revolutions per per | ||||||
sfpm | surface feet |
|
|
|
| minute | |||
|
|
|
| minute |
|
|
|
|
|
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking. Voltage decrease of more than 10% will cause loss of power and overheating. DEWALT tools are factory tested; if this tool does not operate, check power supply.
COMPONENTS (Fig. 1)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could result.
English