Schumacher PSC-12500A owner manual Preparing your battery to be charged, Operating instructions

Page 5

Using an extension cord

The use of an extension cord is not rec- ommended. If you must use an extension cord, please make sure that you follow these guidelines:

Make sure that the pins on charger's power cord fit firmly into the extension cord, and that the extension cord fits firmly into the receptacle.

Check that the extension cord is properly wired and in good electrical condition.

Make sure that the wire size is large enough for its length and for the AC ampere rating, as specified in the chart below.

MINIMUM RECOMMENDED EXTENSION CORD

Length of Cord, in Feet

25

50

100

150

 

 

 

 

 

AWG* Size of Cord

18

16

12

10

*AWG=American Wire Gauge

Preparing your battery to be charged

It is important that you read and follow these guidelines while you are preparing to charge the battery.

Make sure that you have a 6 or 12 volt lead-acid battery. Determine voltage of battery by referring to vehicle owner’s manual or the battery markings. Charge battery initially at charger’s lowest rate.

Clean the battery terminals. Be careful to keep corrosion from getting in or around your eyes or on your hands.

Wear safety glasses. See additional “Per- sonal Safety Precautions” on page 3.

If required, for batteries with removable vent caps, add distilled water to each cell until the battery acid reaches the level recommended by the manufacturer. This will help purge excessive gases from the cells. Be careful not to overfill. If you have a sealed battery with non-removable vent caps, no action is necessary.

Take time to read all of the battery manufacturer’s specific precautions, such as removing or not removing vent caps while charging, and recommended rates of charge.

Be sure that the area around the bat- tery is well ventilated while it is being charged. Gas can be forcefully blown away by using a piece of cardboard or other nonmetallic material as a fan.

If it is necessary to remove the battery from the vehicle to charge it, always remove the grounded terminal from the battery first. Turn off all vehicle acces- sories to avoid sparks from occurring.

NOTE: A marine (boat) battery installed in a boat must be removed and charged on shore.

operating instructions

NOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use.

IMPORTANT: Follow all safety instructions and precautions when charging your battery. Wear complete eye protection and clothing protection. Charge your battery in a well- ventilated area.

Charging Battery In The Vehicle:

1.Avoid personal injury by keeping clear of fan blades, belts, pulleys and other engine parts.

2.Avoid damaging the charger by keeping the power cord and output cords away from the hood, door or moving engine parts.

3.Note the polarity of the battery posts by checking the identification marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or -). The positive post is usually larger than the negative post.

4.Identify which battery post is grounded or connected to the chassis. THIS IS NORMALLY THE NEGATIVE POST.

Image 5
Contents Electronic Table of Contents Remember Important Safety InstructionsPlugging IT Personal Safety PrecautionsBefore Using Your Battery Charger Operating instructions Preparing your battery to be chargedNegative Grounded SYS Engine Starting Notes Using Engine StartGeneral Charging Notes Using your battery chargerOverview ChargeR CONTROLs Battery Type ButtonDigital Display Button Charge Start ButtonControl panel guide Mode of OperationUsing the built-in Battery tester Alternator Testing Notes Using the built-in alternator testerBattery percent and charge time Charging tips Maintenance and CareProblem Possible Cause Solution TroubleshootingWarranty 1540 Table DES Matières AIDEZ-NOUS À Vous Aider Consignes DE Sécurité ImportantesConservez CES Instructions Mesures DE Sécurité Personnelles Préparation DE LA Batterie Pour LA Charge Avant D’UTILISER LE Chargeur DE BatterieBranchement Assemblage DU ChargeurCharge DE LA Batterie Dans LE Compartiment Moteur Consignes D’UTILISATIONUtilisation DE L’AIDE-DÉMAR- Rage Charge DE LA Batterie Hors DU VéhiculeAperçu Utilisation DU Chargeur DE BatterieRemarques Concernant L’AIDE- Démarrage Remarques Générales Bouton DE CHARGE/AIDE-DÉMAR- Rage Tableau DE Commande DU ChargeurBouton DE L’AFFICHAGE NUMÉRI- QUE Page Tableau DE Commande DU Modèle PSC-12500A Guide Tableau DE CommandeSéquence DE Vérification Utilisation DU Vérificateur DE Batterie IntégréTemps D’ATTENTE Limite Après L’ACTIVATION Vérificateur Sans Limite DE TempsPremière Estimation DU % DE Charge Pourcentage ET Temps DE Charge Entretien Conseils Pour LA ChargeAnomalie Cause Probable Correctif Tableau DE DépannageRécemment, mais qu’elle Hicule, allumez lesphares Garantie Remarques 125 Instrucciones de Seguridad Importantes ÍndiceAyúdenos Para Poderle Guarde Estas InstruccionesAntes DE Usar SU Cargador DE Baterías Precauciones DE Seguridad PersonalCómo Enchufarlo EL USO DE UN Cordón DE EXTEN- SiónPara Cargar LA Batería DEN- TRO DEL Vehículo Cómo Preparar SU Batería Para CargarseInstrucciones DE Operación Para Cargar LA Bateríasacada DEL Vehículo Sistema a Tierra NegativoComienza en 5 y cuenta para abajo hasta Cómo Usar EL Arranque DE MO- TOR Engine StartCómo Usar SU Cargador DE Baterías Desulfation Mode Modo DE DesulfatarVista General Notas Generales Respecto AL Proceso DE CargarBattery Type Button Botón DE Tipo DE Batería Botón DE Display Mode Modo DE PantallaControles DEL Cargador Charge Start Button Botón DE Comienzo DE CargaGuia AL Panel DEL Control DEL PSC-12500A Guia AL Panel DEL ControlProbador Y Cargador EL USO DEL Probador DE Baterías IncorporadoSecuencia DE Probar Notas Sobre LA Prueba DE AL- Ternadores EL USO DEL Probador DE Alternadores IncorporadoNotas Para Probar EL % DE Batería Potencia de Régimen de la Batería Porcentaje DE LA Batería Y Tiempo DE CargarMantenimiento Y Cuidado Pautas Para CargarProblema Posible Causa Solución Solución DE ProblemasGarantía