
Fan and Heater | TRANSITION |
|
|
Plenum Thermostat
Mounting
The plenum thermostat is the 4 x 4 white box with knob that is preconnected to heater when heater is ordered with thermostat.
1.24" to the right side of the
transition, drill one 3/8" hole (high temp) or 1 1/2" hole (low temp) in the center of the ple- num in a valley (4.00" corru- gation) or hill (2.66" corruga- tion) on bin sidewall.
2.Insert the probe through the hole.
3.Position the housing so that the tabs are vertical, and the cord exits the housing hori- zontally.
Plenum thermostat mounting on bin wall.
4. Use 4 self drilling screws to | 5. Caulk between the housing |
mount the housing to the bin | and the sidewall to seal. |
sidewall. |
|
1.Mark location on transition one (1) foot up from the bot- tom (entrance collar) and cen- tered in the transition.
2.Drill or knock out 7/8" diam- eter hole on marked location.
3.Install transition
Transition Hi-Limit Installation
Figure 2: The transition connecting the Vane Axial Heater to the bin with
the plenum sensor in place.
53