PROTECTIVE PAD
OUTSIDE AIR PEDESTAL KIT
OUTSIDE AIR DUCT | #10 X 1 | MOBILE HOME FLOOR |
FIGURE 3
DETERMINING THE CHIMNEY LOCATION
1.Suspend a plumb bob from the ceiling above the unit so that the weight is hanging in the center of the flue exit. (A small weight on a string will serve as a plumb bob.) Mark the ceiling where the string is suspended to locate the center of the chimney hole.
2.After locating the center of the hole, install the ceiling support box, chimney, flashing, and rain cap.
CAUTION!!! - Refer to chimney manufacturers instructions for assembly and disassembly of chimney parts. Be sure to follow chimney instructions for proper clearances to combustible and proper air spacing required.
3.Add additional pipe until both of the following are met:
(a)Chimney pipe is 3’ higher than roof at the point where it penetrates the roof. (See Figure 4.)
(b)Chimney pipe height is at least 2’ higher than any part of the roof within 10’ of the chimney. (See Figure 5.)
4.Next, install a New Buck Corporation Chimney Connector to the flue of the heater. (See Figure 4.)
5.Using “Type DVL” double wall chimney connector, connect the heater to the chimney by following
CEILING
SIMPSON DURA- VENT TYPE “DP” CHIMNEY
SIMPSON DURA- VENT TYPE “DVL” DOUBLE WALL CHIMNEY CONNEC- TOR
ROOF
SIMPSON DURA-VENT SQUARE SUP- PORT BOX
NEW BUCK CORP. CHIMNEY CONNEC- TOR
FIGURE 4