SECTION II
| MOBILE HOME INSTALLATIONS | |
| PARTS REQUIREMENTS | |
Listed NEW BUCK CORP. |
| |
Model |
| Part Description/Part # |
ZC20 | Zero clearance cabinet assembly with Model 20 | |
| fireplace installed | |
| New Buck Firestop Radiation Shield # PA 6FRS20 | |
UL Listed and Factory Approved Chimney Systems | ||
|
| Description |
Simpson Dura Vent | - | 6” 2100o HT Type “DP” Chimney |
Security | - | 6” “ASHT” High Temp Chimney |
Selkirk Metal Bestos | - | 6” Model SSII Type HT Chimney |
Metal Fab | - | 6” 2100o HT Chimney |
CAUTION: Read through all of these instructions carefully. Follow approved Chimney Manufacturer’s Installation exactly. Failure to install the Cabinet Fireplace, Stove and Chimney as described in the instructions will void the manufacturer’s warranty and may have an effect on your Homeowner’s Insurance. A major cause of chimney related fires is failure to maintain required clearances (air spaces) to combustible materials. It is of utmost importance that these parts be installed only in accordance with these instructions.
The
INSTALLATION PRECAUTIONS
The following precautions are mandatory for a safe installation:
A.Compliance with local building codes and regulations is mandatory.
B.Be careful not to damage unit in handling and unpacking component parts and accessories.
C.A UL Listed and Approved Chimney System is to be used and vented to the outside of the building. (See chimney list above.)
D.The chimney must extend a minimum of 3’ above the highest point where it penetrates the roof (3’ above a flat roof or up to 2 1/2 pitch roof), and the chimney must extend a minimum of 2’ higher than any portion of the building within 10’ of the chimney. The minimum height is 12’. A 2” clearance must be maintained between the chimney and any combustible materials at all points.
E.A rain cap must be used to terminate the chimney to prevent