KitchenAid W10515677C manual Water Filtration System, Install the Water Filter

Page 10

NOTE: It is easier to adjust the leveling legs if you have another person to assist you.

1.Move the ice maker to its final location.

NOTE: If this is a built-in installation, move the ice maker as close as possible to the final location.

2.Place the level on top of the product to see whether the ice maker is level from front to back and side to side.

3.Push up on the top front of the ice maker, and then locate the leveling screws that are on the bottom front of the ice maker.

4.Using an adjustable wrench, change the height of the legs as follows:

■Turn the leveling leg to the right to lower that side of the ice maker.

■Turn the leveling leg to the left to raise that side of the ice maker.

NOTE: The ice maker should not wobble. Use shims to add stability when needed.

5.Push up on the top rear of the ice maker and locate the leveling legs that are on the bottom rear of the ice maker.

6.Follow the instructions in Step 4 to change the height of the legs.

7.Use the level to recheck the ice maker to see that it is even from front to back and side to side. If the ice maker is not level, repeat steps 2 to 5. If the ice maker is level, go to the “Connect Water Supply” section.

Water Filtration System

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Install the Water Filter

1.Locate the accessory packet in the ice maker and remove the water filter.

2.Take the water filter out of its packaging and remove the cover from the O-rings. Be sure the O-rings are still in place after the cover is removed.

3.The water filter compartment is located in the right-hand side of the ice maker control panel.

4.Using the arrow pointing to the alignment pin on the side of the filter and the arrow inside the control housing, align the alignment pin with the cutout notch and insert the filter into the housing.

A B

C

D

F

E

A. Alignment pin

D. Cutout notch inside control housing

B. Unlocked symbol

E. Arrow pointing to cutout notch

C. Locked symbol

F. Arrow pointing to alignment pin

5.Turn the filter clockwise until it locks into the housing. Ensure that the alignment arrow on the filter head aligns with the locked symbol on the control box housing.

NOTE: If the filter is not correctly locked into the housing, the ice maker will not produce ice.

A

A. Alignment arrow aligned with locked symbol

The Water Filter Status Light

The water filter status lights will help you know when to change your water filter.

A

B D C

A. Cover

C. Alignment pin

B. O-rings

D. Alignment arrow

■The “Order Filter” status light will be illuminated when it is time to order a replacement filter.

■The “Replace Filter” status light will be illuminated when it is time to replace the filter.

■Replacing the disposable water filter with a new filter will automatically reset the filter status tracking feature. See “Using the Controls.”

NOTES:

■“Replace Filter” will remain illuminated if a filter is not installed.

■The “Filter” status light will flash if the filter is not correctly installed or there is an obstruction in the water line.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Manual de uso y cuidado Use & Care GuideGuide d’utilisation et d’entretien Índice Table of ContentsTable DES Matières Cleaning Before Use ICE Maker SafetyInstallation Instructions Unpack the Ice MakerElectrical Requirements Location RequirementsRecommended Grounding Method Vacation or Extended Time Without Use Water Supply RequirementsConnect Water Supply Rear View Drain Pump InstallationIf Ice Maker Is Currently Installed Kit ContainsRear Panel Drain Pump InstallationWater Supply Line Drain TubeDrain Pump Mounting Tab Slot Drain Pump InstalledVent Tube Drain Connection LevelingWater Filtration System Install the Water FilterWater Filter Status Light How Your Ice Maker Works Using the ControlsICE Maker USE Replace the Water FilterICE Maker Care CleaningNormal Sounds Condenser Dirty or Clogged Condenser Interior ComponentsVacation and Moving Care For Ice Makers with a Drain Pump InstalledTo Shut Down the Ice Maker Ice Maker Operation TroubleshootingIce Maker Seems Noisy Ice Maker Runs But Ice ProductionProduces No Ice Canada If you need replacement partsU.S.A Our Consultants Provide Assistance WithPerformance Data Sheet AccessoriesItems Excluded from Warranty Kitchenaid ICE Maker WarrantyThree Year Limited Warranty Parts and Labor Disclaimer of Representations Outside of WarrantyPage Seguridad DE LA Fábrica DE Hielo Su seguridad y la seguridad de los demás es muy importanteRequisitos de ubicación Instrucciones DE InstalaciónDesempaque la fábrica de hielo Requisitos eléctricosVacaciones o tiempo prolongado sin uso Requisitos del suministro de aguaConexión del suministro de agua Vista posterior Instalación de la bomba de desagüeEl juego contiene Línea de suministro de agua Si la fábrica de hielo ya está instaladaTapa de desagüe Instalación de la bomba de desagüeRanura de la lengüeta de montaje de la bomba de desagüe Tubo de desagüeUbicaciones de las piezas Bomba de desagüe instaladaSistema de desagüe por gravedad Conexión del desagüeTubo de ventilación Vista lateralSistema de la bomba de desagüe en algunos modelos NivelaciónConexión del desagüe Instalación del filtro de agua Sistema de filtración de aguaLuz de estado del filtro de agua Uso de los controles USO DE LA Fábrica DE HieloCómo funciona su fábrica de hielo Reemplazo del filtro de aguaSonidos normales Cuidado DE LA Fábrica DE HieloLimpieza Condensador Un condensador sucio u obstruido Bandeja de agua Tapón de desagüeComponentes interiores Tornillo Espaciador de plástico Rejilla de corteCuidado durante las vacaciones y mudanzas Para apagar la fábrica de hieloLa fábrica de hielo no Solución DE ProblemasFuncionamiento de la fábrica de hielo FuncionaProducción de hielo Calidad del hieloEn los EE.UU Problemas de plomeríaAyuda O Servicio Técnico Si necesita piezas de repuestoFiltro de agua Hoja DE Datos DEL RendimientoAccesorios LimpiadorEsta garantía limitada no cubre Garantía DE LA Fábrica DE Hielo DE KitchenaidExclusiones DE LA Garantía Exclusión DE Garantías ImplícitasPage Sécurité DE LA Machine À Glaçons Votre sécurité et celle des autres est très importanteDéballage de la machine à glaçons Instructions D’INSTALLATIONExigences d’installation Spécifications électriquesVacances ou longue période d’inutilisation Spécifications de l’alimentation en eauRaccordement à la canalisation d’eau Vue arrière Installation de la pompe de vidangeContenu de l’ensemble Bouchon de vidange Si la machine à glaçons est installéeInstallation de la pompe de vidange Canalisation d’alimentation en eauPompe de vidange installée Tube de vidangeSystème de vidange par gravité Raccordement au conduit vidangeTube de ventilation Vue latéraleSystème avec pompe de vidange sur certains modèles NivellementRaccordement du conduit dévacuation Système de filtration d’eau Installer le filtre à eauTémoin lumineux de l’état du filtre à eau Utilisation DE LA Machine À Glaçons Utilisation des commandesRemplacement du filtre à eau Fonctionnement de la machine à glaçonsBruits normaux Entretien DE LA Machine À GlaçonsNettoyage Condenseur Un condenseur sale ou obstrué Composants intérieurs Arrêt de la machine à glaçons Précautions à prendre pour les vacances ou le déménagementMachine à glaçons avec pompe de vidange Dépannage Production de glaçons Qualité des glaçonsAux États-Unis Assistance OU ServiceProblèmes de plomberie Au CanadaFiltre à eau AccessoiresFeuille DE Données SUR LA Performance NettoyantÉléments Exclus DE LA Garantie Garantie DE LA Machine À Glaçons KitchenaidGarantie Limitée DE Trois ANS Pièces ET MAIN-D’ŒUVRE La présente garantie limitée ne couvre pasW10515677C

W10515677C specifications

The KitchenAid W10515677C is a versatile and essential component for any home chef who prioritizes both quality and performance in their kitchen tools. This food processor attachment, designed for use with KitchenAid stand mixers, enhances the functionality of the mixer by providing a reliable and efficient method for food preparation.

One of the standout features of the W10515677C is its powerful chopping and slicing capability. With sharp stainless-steel blades, this attachment allows for precise and consistent cuts, whether you're dicing vegetables, grating cheese, or slicing meats. The adjustable slicing disc provides multiple thickness options, making it easy to achieve the desired texture for your ingredients.

The design of the W10515677C is user-friendly, featuring an easy-to-assemble construction that ensures quick setup and minimal hassle. Once attached to the stand mixer, it operates seamlessly, allowing users to focus on their culinary creativity without worrying about the intricacies of food prep.

Another significant characteristic of this attachment is its generous capacity. It can handle large quantities of ingredients, making it perfect for meal preps or when cooking for a crowd. This efficiency saves time and simplifies the cooking process, allowing you to enjoy more time with family and friends.

Safety is also a key consideration in the design of the W10515677C. The attachment features a safety latch that keeps it securely attached to the stand mixer during operation. Additionally, the component comes with a push tool that ensures your hands are kept safely away from the blades while processing food.

Cleaning and maintenance are made straightforward, as most parts of the W10515677C are dishwasher safe, facilitating an easy cleanup after use. This attachment exemplifies KitchenAid’s commitment to durability and quality, built to withstand frequent use in busy kitchens.

In summary, the KitchenAid W10515677C food processor attachment elevates the experience of cooking at home. With its sharp stainless-steel blades, adjustable slicing capabilities, ease of use, and safety features, it stands as a reliable ally in meal preparation. Expanding the capabilities of your KitchenAid stand mixer, this attachment is a practical investment for anyone looking to enhance their culinary skills.
Top Page Image Contents