Frymaster warranty OPERATOR’S Manual Frymaster H52 Series GAS Fryer

Page 1

OPERATOR’S MANUAL FRYMASTER H52 SERIES GAS FRYER

This equipment chapter is to be installed in the Fryer Section of the Equipment Manual.

TABLE OF CONTENTS

MANUFACTURED

BY

FRYMASTER, L.L.C.

P.O. BOX 51000

SHREVEPORT, LOUISIANA 71135-1000

PHONE: 1-318-865-1711

TOLL FREE: 1-800-551-8633

1-800-24 FRYER

FAX: 1-318-219-7135

FOR YOUR SAFETY

Do Not Store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WARRANTY STATEMENT	Page i
INTRODUCTION	Page 1-1
INSTALLATION INSTRUCTIONS	Page 2-1
OPERATING FRYERS WITH M100B COOKING COMPUTERS	Page 3-1
OPERATING FRYERS WITH THERMOSTAT CONTROLLERS	Page 4-1
FILTERING	Page 5-1
PREVENTIVE MAINTENANCE AND TROUBLESHOOTING	Page 6-1

Frymaster, L.L.C. 8700 Line Avenue 71106, 5489 Campus Drive 71129

P.O. Box 51000, Shreveport, Louisiana 71135-1000

TEL 318-865-1711 FAX (Parts) 318-219-7140 (Tech Support) 318-219-7135

PRINTED IN THE UNITED STATES

SERVICE HOTLINE	819-5404 02/05
1-800-24-FRYER	U.S. $6.00

Image 1

Contents OPERATOR’S Manual Frymaster H52 Series GAS Fryer Page General IntroductionEuropean Community CE Specific Information Computer InformationWhat to do if your equipment arrives damaged Service Information General Installation Requirements Installation InstructionsNational Code Requirements Caster/Leg Installation Non-CE Standard For Incoming Gas Pressures Countries Categories GAS Connection to Gas LineCE Standard Gas Vat Converting to Another Gas TypeCE Gas Conversion Kits for Units with Gas Valve Non-CE Gas Conversion KitsFrypot Boil-Out Shutdown Operating Fryers With M100B Cooking ComputersDescription Introduction To The M-100B Cooking ComputerOperating the Computer on Full-Vat Fryers Operating the Computer on Split-Vat Fryers Viewing the Frypot Temperature Actual or SetpointCooking Product Full-Vat or Split-Vat Recovery Out of Range REC Lock M-100B Computer Problem Condition IndicatorsOpen Drain Valve Indication M-100B Computer Set-Up and Programming Instructions Probe Failure IndicationHow to Enter the Setup Mode 1 M-100B Computer Setup ModeHow to Change the Computer’s Display Language How to Configure the Computer for Use on a Gas FryerHow to Change Computer Product/Temperature Displays 2 M-100B Computer Programming Mode How to Activate or Deactivate the Frypot BOIL-OUT FeatureHow to Enter the Program Mode How to Reset the Computer to the Factory DefaultsHow to Change the Cooking Temperature Setpoint How to Enter a Product Name in a Test Menu How to Suppress a Shake, QA, or Duty Function How to Display the Product Cycle Accumulator Information How to Display Use Time InformationHow to Use the Filter Countdown Timer Introduction to the Analog Controller Operating Fryers With Analog ControllersC D E F G H I J K L M N Analog Controller High-Limit Check Page Filtering Operating the Built-In Filtration System Page Operating the Filter Unit Page Getting the Most Out of Your Filter Page Preventive Maintenance Preventive Maintenance and TroubleshootingTroubleshooting REC Lock Troubleshooting Fryers with M100B ComputersIgnition Failure Display Remains Blank When ON/OFF Switches are Pressed Troubleshooting Fryers Equipped with Analog Controllers Did burners Troubleshooting Built-in Filtration System Pump does Not RUN